2. Herman Miller
  3. Zeph Stool

Herman Miller Zeph Stool, Zeph Chair Product Instructions

  • Hello! I'm a chat assistant and I've reviewed the Zeph Tilt Assembly Instruction Manual. This document provides a detailed guide on how to replace the tilt assembly of your chair, including the tools required, the steps involved in dismantling the old assembly, and the process for installing new one. I'm ready to answer any questions you might have about the replacement procedure or the device.
  • What tools are required for the replacement?
    What is the first step in replacing the tilt assembly?
    How do you detach the fender?
HermanMiller ZephTM Installation Assembly Instructions1BV3ZR rev B1
Parts Included
HermanMiller
ZephTM Chair Tilt Assembly Replacement
Instruction Manual
How to Replace Tilt Assembly for Zeph
Chair
Step 2:
Detach the cylinder assembly.
Step 1:
Using a mallet hit both side of the chair and pull o the cylinder assembly
from the tilt assembly.
Tilt Assembly
Tools Required
Mallet Flat Screw Driver
Power Driver 5mm Hex Bit T-30 Bit
HermanMiller ZephTM Installation Assembly Instructions1BV3ZR rev B2
Step 3:
Using the flat screwdriver release snaps in the below location shown.
Step 4:
Detach the fender.
Step 5:
Open one end of the upholstery clip. Then release other end to detach from
the tilt assembly.
Step 6:
Using Trox bit remove all six 1/4-20 pan head screws using 5mm Hex bit and
M6 X 25 flat head screw using T-30 bit to detach the tilt assembly.
HermanMiller ZephTM Installation Assembly Instructions1BV3ZR rev B3
Step 8:
Replace the new tilt assembly and x it to the chair.
Step 9:
Tighten all six 1/4-20 pan head screws using 5mm Hex bit and M6 X 25 flat
head screw using T-30 bit to attach the tilt assembly.
Step 7:
Rotate the tilt assembly upward and move it out to detach from the chair.
Step 10:
Fix the upholstery clip to the tilt slot.
HermanMiller ZephTM Installation Assembly Instructions1BV3ZR rev B4
Step 11:
Attach the fender.
Step 12:
Place the back/seat assembly onto the cylinder. Sit in chair to engage tapers
(cylinder/tilt and cylinder/base).
/