2. Computers & electronics
  3. Computer cables
  4. Cable assembly tools
  5. Herman Miller
  6. Asari Chair by Herman Miller

Herman Miller Asari Chair by Herman Miller Product Instructions

  • I'm a chat assistant and I've reviewed the HermanMiller Asari Recycling Instructions. This document details the steps and tools required to disassemble the Asari chair for recycling, including the removal of components like the arms, back, seat, tilt mechanism and cylinder. I'm ready to answer your questions about the recycling process.
  • What tools are needed for disassembly?
    How many screws need to be removed in Step 1?
    What type of bit is used to remove the arm pad retainer bolt?
    What tool should be used to remove the cylinder from the base?
Tools required
HermanMiller
Asari Recycling Instruction
How to disassemble your Asari
Step 2 Step 3
. Using T- torx bit, unscrew the arm pad retainer bolt and take out
the arm pad.
. Detach the arms from the chair.
. Use power drive to remove six (three screws on each side) M Screws.
Power Driver
Hammer Li o Tool Mallet Nylon Cap 13mm Socket
T-25 Bit T-15 BitTorque Wrench M5 Driver Bit 4mm Hex Bit #2 Square bit
Step 1
Recycling Instructions1HermanMiller 1BW9F8 Rev A
HermanMiller Recycling Instructions1BW9F8 Rev A2
Step 5
. Remove T- screw using a power driver.
Step 4
. For armless chair, remove # square drive screw using a power drive to
detach the arm plug.
Step 6 Step 7
. Remove the mm bolts from the J-bar using power drive.. Detach the J-bar cover.
HermanMiller Recycling Instructions1BW9F8 Rev A3
Step 9
Step 10
. Remove # square drive screw using a power driver to detach the
seat cover.
. Detach the seat cover.
Step 8
. Detach the back from the chair.
Step 11
. Remove three T- screws to remove the height adjustable mechanism.
HermanMiller Recycling Instructions1BW9F8 Rev A4
Step 13
Step 14
. Use a flat screw driver and push out the cable from the
mechanism to detach it from the tilt assembly.
. Remove two mm button head screws from the bracket to
remove the seat.
Note: For Armless chair, remove six mm button head screws.
Step 12
. Detach the height adjustable mechanism from the chair.
Step 15
. Detach the seat from the chair assembly.
HermanMiller Recycling Instructions1BW9F8 Rev A5
Step 17
Step 18
. Use a hammer and li o tool to detach the tilt from the
base assembly.
. Use a rubber mallet and the nylon cap strike gently to remove the
cylinder from the base.
Step 16
. Remove four mm hex bolts to detach the tilt assembly.
. Detach tilt adapter from base assembly.
Step 19
. Pull o the caster from the base.
/