Goodway RAM-5 User guide

Brand: Goodway

Model: RAM-5

Type: User guide

RAM-5 Quick Start Guide

Using The Speed Feed Gun

PLEASE REVIEW

IMPORTANT SAFETY

INSTRUCTIONS

LOCATED IN

OPERATORS MANUAL

* Accessories sold separately

Attach the dolly to the base by laying the

machine at and tightening the screws by

hand.

Thread the guide tube assembly and the air

lines on to the side of the machine. Make

sure the drain box is vertical.

1 2

Proper Startup

Essentials

The two air lines need to be connected

above the shaft outlet. The air line

without the tag on the left, the air line

with the “Forward” label on the right.

3

4

Once the machine is plugged in and the GFCI has

been reset, walk the gun assembly out so it is not

coiled, feed the cable into the side of the machine

and out the guide tube assembly by pulling the

trigger on the gun. Do this before the cable has

been connected to the manifold and a brush has

been attached to the end of the cable.

Insert shaft male coupling into

shaft manifold then push shaft nut

into locking collar to lock in place.

5

MACHINE

MUST LAY

FLAT ON

DOLLY

WHEN IN

USE

Attach the brush to the shaft by sliding the quick connect coupling towards the cable and

placing the brush into the tting. Measure out the length of cable you will need and tighten the

shaft stop (Note: brush should extend out the back of the HEX tube only as far as the brush stem).

Refer to manual for proper length.

7

GOODWAY® TECHNOLOGIES CORPORATION

420 West Avenue, Stamford, CT 06902 USA

Tel: 203-359-4708 · Toll-Free Tel: 800-243-7932

Fax: 203-359-9601 · Toll-Free Fax: 800-359-9625

Email: goodway@goodway.com

Visit: www.goodway.com

HVAC & FACILITY MAINTENANCE SOLUTIONS

Attach a water

hose to the

machine and

turn the water

supply on.

6

FNL 0823

1
2
3
4

Goodway RAM-5 User guide

Brand: Goodway

Model: RAM-5

Type: User guide

Download PDF

Related papers

Other documents