USER MANUAL
SLAMMERS
WIRELESS
HEADPHONES
JB. 5815-a / Made in China. © KitSound is a trademark of Kondor Limited, 2017.
Christchurch, Dorset, BH23 4FL, UK
All trademarks are acknowledged as the property of their respective owners.
Unless otherwise stated their use does not imply that the trademark owner is aliated
with KitSound or endorses the products herein.
Warning: To prevent possible hearing damage, do not listen at high volume levels for long
periods. For your own safety, please be aware of your surroundings when using these
earphones. Not suitable for children.
Your product and batteries must be recycled or disposed of properly.
Please contact your local recycling centre for more information on proper disposal.
kitsound.co.uk
2 3
Please read this manual carefully before use.
Box contents
• KS Slammers Wireless Headphones
• Micro USB charge cable
• 3.5 mm aux cable
• User manual
Functions
1. Next track/Volume+
2. LED indicator
3. Previous track/Volume–
4. Multi-function button (MFB)
5. Micro USB charging port
6. 3.5 mm Aux port
7. Microphone
Instructions for use
Charging the battery
1. Connect the Micro USB charging cable to the Micro USB charging
port (5) and plug into power
2. The LED indicator (2) will be red whilst charging, and nish
after around 2 hours. The LED indicator (2) will turn solid blue
once charged
Note: If the LED indicator (2) ashes red twice every 30 seconds and
a warning beep is heard, the battery is low.
Note: The rst charge may take up to 3 hours to complete.
1
2
3
4
5
6
7
4 5
Pairing a wireless device
1. Hold the MFB (4) down for 3 seconds. You will see the LED indicator (2)
ash blue and red and enter pairing mode
2. Turn on your iOS, Android, or Windows device’s Bluetooth ON and
search for new devices
3. Select ‘KS Slammers’ from the list of found devices. If asked for a
passcode, enter ‘0000’ or ‘1234’ and the headphones will then be
connected to your device
4. After pairing successfully, the LED indicator (2) will have a ashing
blue light; you can then answer the phone or listen to your music
5. The next time you switch the headphones on; they will automatically
search for and attempt to connect to the last paired device
Note: ‘Bluetooth’ is a trademark of Bluetooth SIG, Inc. This product is
in no way aliated or endorsed by Bluetooth SIG Inc.
Re-pairing or pairing new devices
1. Make sure you have turned o the wireless connectivity on any
previously paired devices
2. Follow the ‘Pairing a wireless device’ instructions from step 1
Call handling
Answer a call Press MFB (4) to answer. You can increase the
volume by using Volume+ (1) or Volume– (3)
Reject a call Hold MFB (4) to reject the incoming call
End call Press MFB (4) while in the call to end it
Re-dial Press MFB (4) twice in quick succession to redial
the last phone number you called on your device
6 7
Playing music
Play/Pause Press (don’t hold) MFB (4)
Adjusting the volume Hold Volume+ (1) or Volume– (3). The volume
can also be adjusted on your device
Music selection Press Next track (1) or Previous track (3)
Wired use
1. Turn o the headphones
2. Plug the 3.5 mm Aux cable into the 3.5 mm Aux port (6) and into
your device
Note: All functions are controlled via your device.
Care for your Slammers
Please DON’T:
• Get the Slammers wet
• Drop the Slammers as this will invalidate your warranty
• Open up the Slammers. There are no user serviceable parts inside
• Expose the Slammers to extreme temperatures or rapid changes of
hot to cold or vice versa
Please DO:
• Clean the Slammers with a soft dry cloth and no detergents
8 9
Specications
Works with Bluetooth
®
V4.2
Wireless connectivity distance up to 10 m
Frequency response 20 Hz – 20 kHz
S/N 102+-3 dB
RMS output 0.025 W
Talk time up to 4 hours
Play time up to 5 hours
Charging time up to 2 hours
Standby time up to 120 hours
Battery type 3.7 V, Lithium Polymer
250 mAh, rechargeable
Power requirement 5 V DC
Battery information
• A rechargeable battery powers your device. Unplug the charger from
the electrical plug and the device when not in use
• If left unused, a fully charged battery will lose its charge over time.
We recommend a full charge twice a month to ensure battery integrity
• Please do not leave the device in hot or cold places, such as in a
closed car in summer or winter conditions, as it will reduce the
capacity and lifetime of the battery
• Do not dispose of batteries in a re as they may explode. Batteries
may also explode if damaged
10 11
Troubleshooting
• If you cannot connect the headphones to your device, please try
the following:
– Ensure that the headphones are charged, switched on, paired
with and connected to your device
– Check the headphones are within 10 metres (30 feet) of your
device and that there are no obstructions (such as walls or other
electronic devices) between the headphones and the device
– The headphones can only pair to one device at a time, so please
ensure there are no conicting wireless devices trying to connect
to the headphones
• If the headphones will not switch o, you can reset them back to
normal by putting them on charge
• If you receive an intermittent signal, please ensure the headphones
are fully charged before continuing use
We hope you've now got all the information you need to get started,
but if you're having problems with anything, please feel free to contact
us at: suppor[email protected].uk
Hereby, Kondor Ltd declares that the radio equipment type,
KSSLAMRBK Slammers Wireless Headphones, is in compliance
with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following
internet address: http://kondor.co.uk/product-documents.
Please do not attempt to open this product. There are no user serviceable parts inside.
If your product has an embedded, non-replaceable battery, do not attempt to access
or remove the battery. This may cause personal injury and will damage the product.
Making any attempt to open the product or carry out repair voids any and all warranties.
We apologise for any inconvenience caused by minor inconsistencies in these instructions,
which may occur as a result of product improvement and development.
/
