Cooper Lighting INVUE VFM Vision Flood-Medium User manual

Cooper Lighting
Brand
Cooper Lighting
Model
INVUE VFM Vision Flood-Medium
Category
Work lights
Type
User manual

This manual is also suitable for

These instructions do not claim to cover all details or variations in the equipment, procedure, or process described, nor to provide directions for meeting every possible
contingency during installation, operation or maintenance. When additional information is desired to satisfy a problem not covered sufficiently for user’s purpose, please
contact your nearest representative.
1. Using 3/16” Allen Wrench, remove wiring
compartment cover.
2. Feed supply leads through fitter and out wireway
compartment opening. Slide fitter over tenon.
3. Tighten (4) set screws to 225 in. lbs. using 3/16”
Allen Wrench.
4. Splice supply leads to fixture leads making sure to
ground the fixture in a manner that complies with
National Electric Code and applicable local codes.
DO NOT USE POLE AS GROUND. Push wires in to
wiring compartment and reinstall cover and gasket.
Customer First Center • 1121 Hwy 74 South • Peachtree City, GA 30269 IMI-563 AVU032732
VFM Vision Flood-Medium
Fitter Mount
Sheet 1 of 1
10/09/03 IMI-563
INSTALLATION INSTRUCTIONS
IMPORTANT: Read carefully before installing fixture. Retain for future reference.
General: Upon receipt of fixture thoroughly inspect for any
freight damage, which should be brought to the attention of
the delivery carrier. Compare the catalog description listed
on the packing slip with the fixture label on the housing to
assure you have received the correct merchandise.
Safety: This fixture must be wired in accordance with
the national electrical code and applicable local codes
and ordinance. Proper grounding is required to insure
personal safety. Carefully observe grounding procedure
under installation section. All work should be done by a
qualified electrician.
TM
WARNING: Risk of Electric Shock. Disconnect power at fuse or circuit breaker before installing
or servicing.
GASKET
FITTER
FIXTURE
LEADS
1/4-20 BOLT
SUPPLY LEADS
WIRING
COMPARTM
COVER
2-3/8" OD TENON
ALLEN WRENCH
SET SCREWS
5. Loosen fitter bolt using 3/8” Allen Wrench and
adjust fixture to desired aiming angle. Retighten bolt
to a minimum of 250 in. lbs.
6. Open door using 3/16” Allen Wrench and install
lamp.
REFLECTOR AND LENS CLEANING
1. Open fixture door.
2. Dust reflector with soft, clean dry cloth.
3. Clean lens with any non-abrasive glass cleaning
solution and rinse with clean water.
4. Wipe lens dry with clean, dry cloth.
NOTE: A regular maintenance schedule should be
followed to retain optimal light output and reduce
heat retention.
DO NOT use alkaline or acid cleaners on reflector
surfaces.
A
LLEN WRENCH
FITTER BOLT
TOOLS REQUIRED: 3/16” Allen Wrench
3/8” Allen Wrench
  • Page 1 1

Cooper Lighting INVUE VFM Vision Flood-Medium User manual

Cooper Lighting
Brand
Cooper Lighting
Model
INVUE VFM Vision Flood-Medium
Category
Work lights
Type
User manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents