Page is loading ...
FIG-1 FIG-3
Concrete
FIG-6 FIG-7
FIG-2
Note: In order to reach the required IP,
the input cable for the luminaries must be
H05RN-F 3×1.0mm², and threading
through before stripping.
Note: Please keep the cable
outlet in the same vertical
direction with the inlet to
luminaries
FIG-4
80MM
FIG-5
VER:1.0
1
2
green/yellow
brown
blue
L
N
NL
0.5-2.5mm² with
release facility
please note that the electric
cable opening should come
through the top of the fixture.
3
after tightening the screws,
please seal the hole with
water-repellant glue.
1
INPUT
3
2
1
2
2
1
1
2
!
for cable/pipe mm: ∅5-10
H05RN-F 3×1.0mm²
EX913 B34
1
OFF
ON 2
1
OFF
ON 2
4000K
3000K
Attention:
when switching the color
temperature, please make
sure the power is off.
If the external flexible cable or cord of this luminaire is damaged, it shall
be exclusively replaced by the manufacturer or his service agent or a
similar qualified person in order to avoid a hazard.
The light source of this luminaire is not replaceable;
when the light source reaches its end of life the whole luminaire shall
be replaced.
This luminaire must be installed by a qualified Registered Electrician to
prevent damage to the luminaire and maintain electrical safety.
Base plate,cable entry gland and screw heads must be covered in silicon
sealant. Failure to do so may cause luminaire failure from water ingress.
All exterior luminaires (with the exception of copper) require periodic
cleaning to protect the surface and/or coating from corrosion and ensure
tidy appearance for the lifespan of the product. Wash with care using a
soft brush and warm soapy water using a neutral detergent. Coastal
areas require extra attention, especially fittings which are under
eaves/soffits and do not have any exposure to rain. Do not use a water
blaster or high pressure hose, do not submerge fittings for extended
periods of time. 316 stainless steel fittings will still develop surface
rust or “tea staining” if left uncared for.
/
