FIG-2-A
FIG-4
FIG-3 FIG-5
FIG-1
Concrete
0.5-2.5mm² with
release facility
3
43MM
2
1
2
1
1
3
67MM
wrench,gasket
FIG-2-B
Wood board
Please make sure the
thickness of the wood
board no less than 5mm
Gasket
2
1
Freely choose tool
to fix the backstand.
Note: Please keep the
cable outlet in the same
vertical direction with the
inlet to luminaries
Note: In order to reach the required IP,
the input cable for the luminaries must
be H05RN-F 3×1.0mm², and threading
through before stripping.
ver:1.1
Pri:220-240V
Please install the side
marked with “up” label in
the top for backstand.
UP
for cable/pipe mm: Ø5-10
H05RN-F 3×1.0mm²
EX153
If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufacturer
or his service agent or a similar qualified person in order to avoid a hazard.
The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole
luminaire shall be replaced
This luminaire must be installed by a qualified Registered Electrician to prevent damage to the luminaire and maintain
electrical safety.
Base plate,cable entry gland and screw heads must be covered in silicone sealant. Failure to do so may
cause luminaire failure from water ingress.
1
OFF
ON
2
1
OFF
ON
2
1
2
green/yellow
brown
blue
N L
N
L
All exterior luminaires (with the exception of copper) require periodic cleaning to protect the surface and/or coating
from corrosion and ensure tidy appearance for the lifespan of the product. Wash with care using a soft brush and
warm soapy water using a neutral detergent. Coastal areas require extra attention, especially fittings which are
under eaves/soffits and do not have any exposure to rain. Do not use a water blaster or high pressure hose, do not
submerge fittings for extended periods of time. 316 stainless steel fittings will still develop surface rust or
“tea staining” if left uncared for.
Caution,risk of electric shock.
2
3
29MM
Ø6MM
/
