Atleisure UMB-952590 Assembly & Care Instructions

Brand: Atleisure

Model: UMB-952590

Type: Assembly & Care Instructions

8.5ft Square Oleﬁn

Offset Umbrella

Assembly & Care Instructions

IMPORTANT : RETAIN FOR FUTURE REFERENCE

READ CAREFULLY

Item: UMB- 952590

M51775

ATLeisure, LLC

Toll Free: 1-855-880-7205 (English is offered)

8am - 5pm, Monday through Friday, Eastern Standard Time

Email: customerser[email protected] or visit our website at www.atleisure.com

DO NOT RETURN TO STORE

For indoor/outdoor domestic use only. Not for commercial use.

Designed in USA

Made in China

For assistance with assembly, parts, or customer service, please contact:

Contents

Package Contents ............................2

Assembly ...................................3

Replacement Parts ...........................4

Care and Maintenance .........................4

Warnings and Cautions ........................4

Warranty ...................................5

Before assembling make sure all parts are present. If any part is missing or

damaged, do not attempt to assemble the product. Contact our customer service

representative for assembly assistance or questions toll free at 1-855-880-7205.

Package Contents

Part Description Quantity

C Lower Cross Leg 1

D Upper Cross Leg 1

F Holder Pole (with control knobs) 1

N Umbrella Frame (with canopy) 1

GG Bolt 4

HH Washer 4

7 Crank 1

Assembly

Step 1: Place the Upper Cross (D) over Lower Cross Leg (C) to

form an “X” as shown.

Step 2: Attach the Holder Pole (F) to the cross legs (C & D) with

the Bolts (GG) and Washers (HH) to be sure it is positioned

correctly on the base. Finally, tighten all bolts. Be careful not to

overtighten.

Assembly

Control Knob

Holder Pole Ring

Step 3. Insert the main pole of the

Umbrella Frame with Canopy (N) into the

Holder Pole (F) until the lower ﬁxed stop pin

sits on th Holder Pole Ring as shown. Tight-

en the two control knobs into the Holder

Pole (F) to secure the umbrella.

Step 4. Use the appropriate anchors

to permanently attach the base to your

wooden deck or concrete patio, or

use patio stones or an offset umbrella base

(sold separately) to anchor the umbrella.

Assembly

Step 5. Unfasten to storage straps

around the canopy as shown.

Step 6. Open the umbrella. Pull out

the lever clamp to release the glide

handle as shown. Grasp and slide the

glide handle up along the umbrella pole.

Turn the crank handle in the open

direction. Open the canopy until the

lower center hub reaches the end of the

support pole where the canopy has the

proper tension. Push down the lever

clamp to lock the glide handle against

the umbrella pole. This determines the

tilt of the umbrella canopy.

Step 7. If the canopy does not cover your

patio as expected (does not offer shade

to the area), you may need to adjust the

position of the canopy. Loosen the control

knobs and turn the umbrella pole around

its axis to adjust the canopy. Finally, make

sure to tighten the control knobs to

secure the umbrella.

If the crank becomes too hard to crank,

check to see if the rope has come off

the pulley. If you continue to turn the

crank, the rope could break. Contact our

customer service toll free at 1-855-880-

7205 for further assistance.

Storage

Straps

Replacement Parts

Part Description Quantity Re-order No.

C Lower Cross Leg 1 CSL-C58X-BRZ-T

D Upper Cross Leg 1 CSL-D58X-BRZ-T

F Holder Pole (with control knobs) 1 HDP-F58X-BRZ-T

N Umbrella Frame (with canopy) 1 CAN-8.508RBO-T-RD, TN,

TO, BL

GG Bolt 1 HDW-GG-T

HH Washer 4 HDW-HH-T

7 Crank 1 CRK-758G-BRZ-T

Additional Operation Instructions

The umbrella has a unique design that

allows the pole to move off to the side.

The multi-position canopy can rotate 360˚

around the axis of the main pole to offer

maximum shade to your patio.

Canopy

open

Lever clamp

Glide handle

Crank handle

Open

Glide handle

Release

Lock

Care and Maintenance

Warnings and Cautions

• Always take the umbrella down when not in use.

• Keep children away from umbrella during assembly to avoid injury.

• To prevent damage to the canopy, open the umbrella facing the opposite direction that

the wind is blowing.

IMPORTANT:

Do not use this umbrella during periods

of high winds and rain. Failure to do so may result in

personal injury and/or damage.

Warning: Placement of the umbrella over or near a swimming pool can cause premature

fading of the canopy. This is not covered under our warranty.

• DO NOT machine wash or dry.

• DO NOT iron.

• AIR DRY the canopy thoroughly before storing for extended period of time.

CANOPY CARE INSTRUCTIONS:

Simply clean the umbrella canopy with soft br

ONE YEAR WARRANTY

This product is covered under a manufacturer’s one year warranty from date of

purchase against defects in materials and workmanship. This warranty does not

cover damage due to neglect, abuse or weather related damage. For full warranty

disclosure, email us at customerser[email protected], call toll free at 1-855-880-

7205 or send mail to: 1040 Boulevard SE Ste. B, Atlanta GA 30312

HOW TO FILE A CLAIM

If you are within your warranty you must have your receipt and pictures of your

information to send to ATLeisure at customerser[email protected], or send

by mail to 1040 Boulevard SE Ste. B, Atlanta GA 30312. This warranty gives you

speciﬁc legal rights, and you may also have other rights which vary from state to

state.

Warranty

ush

ATLeisure, LLC

1040 Boulevard SE, Suite B

Atlanta, Georgia 30312, USA

Customer Service Toll Free 1-855-880-7205

8am - 5pm Eastern Time, Monday through Friday

www.atleisure.com

Atleisure UMB-952590 Assembly & Care Instructions

Brand: Atleisure

Model: UMB-952590

Type: Assembly & Care Instructions

Download PDF

report

Atleisure UMB-952590 Assembly & Care Instructions

Atleisure UMB-952590 Assembly & Care Instructions

Related papers

Other documents