ACT ACTPRO 1030 PANEL MOUNT READER Installation guide

Brand: ACT

Model: ACTPRO 1030 PANEL MOUNT READER

Type: Installation guide

Installation diagram for ACTPro

1030 Panel Mount Reader

U nit 8 Tallaght B usiness Centre, W hitestown, T allaght, Dublin 24, Ireland.

Telephone: 353 1 462 2585. T elefax: 353 1 462 2587. E -mail: s ales @ accesscontrol.ie W eb: www.accesscontrol.ie

The above diagram is valid only

for clock-and-data type readers.

The +5V reader supply on ACT controllers is normally rated

at 100mA. Typically this is sufficient to power 2 ACT readers.

Note however that readers from other manufacturers may need

to be powered separately if their current requirements exceed

this or if they require 12V.

OMRON

5-12V dc

0 1 2 3 4 5 6 7 8 9

B AT C H:

P R ODU C T

S E R IA L N UMB E R

03XX -10

AC T PM R E V1.1

00XX XX

Data / D0

Clock / D1

Sense

R ed L ED

Grn L ED

B uzz Ctrl

Internal buzzer is

activated by applying

0V to Buzz Ctrl

Rear view of ACTPro 1030 Panel Mount Reader

connected to the ACT2000/1000/DS100

White

Green

Blue

Red

Black

Brown

Yellow

Orange

Sense

Clock / Data1

Data / Data 0

+5v

Red Led

Grn Led

(Buzzer Ctrl)

Wiring for Clock and Data / Wiegand Reader

The standard wiring colours for

ACTPro 1030 Panel Mount Proximity

reader is shown above. Readers should

be a maximum of 30m from the

controller when powered from +5V

and a maximum of 100m when

powered from +12V.

Mounting Instructions

1.Place the vr screen printed

perspex over the 4 studs

on the back of the audio

entry panel.

2.Place the ACTPro 1030

Panel Mount reader over

the 4 studs.

3.Use the 4 M3 washers and

nuts supplied with the

product to secure the

reader to the audio entry

panel.

4.Use the wiring diagram

below to connect the reader

to the controller.

5.When wiring is complete

place the front cover back

onto the audio entry panel.

6.Apply power to the

controller and test the

reader with a card or fob.

ACTPro 1030

Panel Mount

reader.

VR Screen printed perspects

M3 washers

and nuts

Audio entry panel

5 6

LED

OFF

LED Control

The standby LED on the front of the reader

can be configured using the link wire.

When the link wire is connected between

LED and OFF the red LED on the front of

the reader will remain off while in standby

and will turn green on access granted.

When the link wire is connected between

LED and ON the red LED on the front of

the reader will remain on while in standby

and will turn green on access granted.

ACT ACTPRO 1030 PANEL MOUNT READER Installation guide

ACT ACTPRO 1030 PANEL MOUNT READER Installation guide

ACT ACTPRO 1030 PANEL MOUNT READER Installation guide

Related papers

Other documents