Microdia FlashMover PhotoBan Installation guide

Brand: Microdia

Model: FlashMover PhotoBan

Type: Installation guide

PHOTOBANK

INSTALLATION GUIDE

Thank you for purchasing MICRODIA

FlashMover

PhotoBank. The FlashMover

PhotoBank works with USB

enabled Microsoft Windows 98SE, ME, 2000, XP or above, Linux Kernel 2.4 or higher, and Mac 10.2 and higher

systems. This installation guide contains all the information you need to install your FlashMover

PhotoBank.

FlashMover PhotoBank Installation Guide

Nov 2006 MICRODIA Ltd.

For Windows ME/2000/XP/2003, Linux 2.4, Mac OS 10.2.x

1. No software setup is needed. Windows 2000 must have at least Service Pack 3 installed, and Windows XP

must have at least Service Pack 1 installed

For Windows 98/98SE/2000 without SP3

1. The driver provided on the CD is required only for Microsoft Windows 98 and Windows 2000 without SP3.

2. After software installation is completed, turn on the PhotoBank and connect it to the computer using the USB

cable provided.

3. You computer will atomically search for the device driver and install it.

NOTE:

- Please Turn [DC/BAT] to [DC] and connect the AC power adapter.

- Please complete the installation before connecting the PhotoBank to your Wins 98 computer

Disconnecting PhotoBank

For Windows 2000 and XP

1. Left click on the [Unplug or Eject Hardware] or [Safely Remove Hardware] icon in the Windows system tray

(Green arrow icon on right of your task bar)

2. Select [Stop USB Mass Storage Device] (For Windows 2000) or [Safely Remove USB Mass Storage Device]

(For Windows XP) and confirm.

For Windows ME

1. Left click on the [Unplug or Eject Hardware] icon in the Windows system tray (Green arrow icon on right of

your task bar)

2. Select [Stop USB Disk – Drive(X:)] or the appropriate drive letter and confirm.

NOTE: The PhotoBank appeaers as three separate drives in Windows ME system tray icon, so go through Step 1 and

2 until all three drives are disconnected.

For Windows 98/98SE

1. Open [My Computer Control Panel System Device Manager]

Right click on the PhotoBank

Select [Remove] and then disconnect your PhotoBank

NOTE: Unplug the USB cable only when prompted or there is no data transfer evident. If not, you may damage you

data in the PhotoBank. If this happen, you may use the Windows scandisk utility and attempt to repair any

damaged data on the hard disk.

Most problems or technical issues can be resolved by simply visiting our Support Section in MICRODIA

website,

www.microdia.com

or send us an email to [email protected]om.

Microdia FlashMover PhotoBan Installation guide

Microdia FlashMover PhotoBan Installation guide

Microdia FlashMover PhotoBan Installation guide

Related papers

Other documents