AD917RK

Rack Mount Kit

for 917 Series 17 Inch B/W Monitors

INSTALLATION INSTRUCTIONS

I. UNPACKING of RACK KIT

Inspect the contents of the Rack Mount Kit for damage that may have occurred during shipping. Report any damage immediately to

the shipper.

1. Save the shipping carton and these instructions.

Front cover 1

II. ASSEMBLY and INSTALLATION INSTRUCTIONS

This rack mount kit is designed for compatibility with all EIA Standard RS-310 equipment (see EIA -310- rev C).

1. Lay the chassis plate on a clean, flat surface (10-32 studs facing down).

2. Attach the left and right rack mount ears to the chassis plate using 10-32 Hex nuts (supplied).

3. Attach the front cover to the chassis plate assembly (the brace across the rear of the front cover is UP).

4. Remove the rubber pads from the bottom of the monitor before inserting through the rear of the rack assembly.

5. Center the monitor's pad screw holes over the chassis plate mounting holes. Secure the monitor to the chassis plate using the

screws/washers from the rubber pads.

You are now ready to mount the assembled unit into the rack.

OP0917RKB

July 1994 Made in U.S.A.

Information furnished by AMERICAN DYNAMICS is believed to be accurate and reliable. However, no responsibility is assumed by AMERICAN

DYNAMICS for its use; nor for any infringements of other rights of third parties which may result from its use. No license is granted by implica-