BLOTZ B28-AF-103 Assembly Instructions

  • Hello, I have reviewed the provided instructions for the BLOTZ 28mm Upright Piano and Chair model B28-AF-103. This document provides detailed step-by-step instructions for assembling the model, including the use of glue and other tools. I am ready to answer any questions you may have about the construction process.
  • What type of glue is needed for the assembly?
    What tools are needed for the assembly?
    Can I find a full color copy of these instructions online?
28mm Upright Piano and Chair
B28-AF-103
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
A full-colour copy of these instructions can be found on our website: www.blotz.co.uk
Each chair is formed from the pieces shown
above. Apply a little glue to the underside of one
short end of the seat. Stick this to the top of the
bar on the chair back.
Apply glue to the underside of the other end of the
seat and attach the front legs.
The piano is formed from the pieces shown
above.
Start by attaching the keyboard to the front of the
piano, then glue the ends in place.
Attach the base and top of the piano.
Finally attach the back.
/