2. Legrand
  3. QIS
QIS

Legrand QIS, QIS Wall Switch (1st Gen Power Panel) Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Legrand QIS Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
  • What should I do when the shade does not respond to the wall switch?
    How do I set the upper or lower limit for the shade's movement?
    What is the function of the PRESET buttons on the wall switch?
    Can I use a single-channel wall switch to control multiple shades?
    What is the purpose of the HEMBAR tug during the pairing or unpairing process?
    What should I do if I need to replace the wall switch battery?
    How can I troubleshoot connection issues between the wall switch and the shade?
www.qmoonshades.com Pensacola FL, 32514 1 -877-849-6070 1
PN 9000228
QIS Wall Switch
Programming Instructions
FIRST TIME SETUP
1. INSTALL SHADE following appropriate installation instructions
2. CONNECT POWER SUPPLY to Power Communication Panel
3. CONNECT SHADE to Power Communication Panel using network cable
_ (Shade will JOG on initial power-up)
4. CONNECT WALL SWITCH to Power Communication Panel using network cable
PAIRING / LEARNING WALL SWITCH (or Channel)
1. PRESS both UP and PRESET 1 at the same time
(Shade will JOG in response)
2. TUG the HEMBAR 6-10 inches
(Shade will JOG in response and is now paired)
UNPAIRING / UNLEARNING WALL SWITCH (or Channel)
1. PRESS both DOWN and PRESET 2 at the same time
(Shade will JOG in response)
2. TUG the HEMBAR 6-10 inches
(Shade will JOG in response and is now unpaired)
Dual Channel
Wall Switch
IMPORTANT
Read and understand each section before performing required steps
When using a Dual Channel Wall Switch, the left button column corresponds to Channel 1. The right button column
corresponds to Channel 2 as shown in the diagram below.
CH 1
CH 2
Single Channel
Wall Switch
When learning new positions, the button currently being programmed (after Step 3. TUG) will not send commands to the shade.
Example 1: When learning a new PRESET 1 position, pressing PRESET 1 will do nothing (after Step 3. TUG). The shade can still be
adjusted using the UP and DOWN buttons.
Example 2: When learning a new upper limit position, the UP button is semi-disable. Only by pressing the UP button 3 times will the
shade move to the up position (or manually roll the shade up by hand). After Step 5 all buttons resume full functionality.
SETTING UPPER AND LOWER LIMITS / LEARNING A NEW POSITION
(Must use paired Wall Switch)
1. PRESS the (UP, DOWN, or PRESET) button that will be programmed (Shade will move to selected position)
2. PRESS and HOLD the same (UP, DOWN, or PRESET) button UNTIL shade JOGS
3. TUG shade 6-10 inches (Shade will JOG in response)
4. ADJUST shade to desired position ( Use UP/DOWN buttons or manually adjust shade by hand)
5. PRESS and HOLD the same (UP, DOWN, or PRESET) button (Shade will JOG when learned)
IMPORTANT
www.qmoonshades.com Pensacola FL, 32514 1 -877-849-6070 2
PN 9000228
Power Supply: 24 VDC, 7.5A
RJ-45 Ports for Motorized Shades and Switches - Quantity 8
Communication Ports (RJ-45) - Quantity 2
Qadvanced Intelligent System
(QIS) System Overview
CAT5e or CAT6 Cable Required for Network Connections (RJ-45)
/