Page is loading ...
AUTOMATE
™
ARC Tubular Motor
Quick Start Guide
1. Mount the shade. 2. Wake up the shade by holding P1 (approx. 2 seconds),
until shade jogs 1x and beeps 1 long beep.
3. Your shade is now ready!
Use the UP and DOWN arrows to operate
the shade. If using a 15 channel remote,
rst select the programmed channel.
Hold P1
For more in depth motorization programming instructions, please visit vistaproducts.com/guides
LOCK/UNLOCK THE REMOTE
1. Remove the battery cover
from the back of the remote.
2. Hold the LOCK button until...
A) If 15 channel remote:
- To Lock: ...hold until the 'U' on the screen turns into an 'L'.
- To Unlock: ...hold until the ‘L’ on the screen turns into an ‘U’.
B) If single channel remote:
- To Lock: ...hold until the blue light is solid
- To Unlock: ...hold until the blue light blinks
Lock
A) B)
Blue Light
V
i
s
t
a
Adjusting Upper and Lower Limits
The upper and lower limits have been set at the factory.
NOTE: The remote must be unlocked before adjusting the limits. Adjusting limits needs to be done with a hand held remote;
a wall switch remote may not be used. When adjusting one shade, any other shades on the same channel need to be
temporarily unlinked from the remote. Once the limit is set,relink “turned off” shades.
Visit vistaproducts.com/guides for instructions on how to LINK AND UNLINK A SHADE.
ADJUSTING LOWER LIMIT
ADJUSTING UPPER LIMIT
For more in depth motorization programming instructions, please visit vistaproducts.com/guides
1. Hold UP and STOP on controller
until the shade jogs 1x and beeps 1x.
2. Move shade to the desired highest position
by using the UP or DOWN button.
3. To save upper limit, hold UP and STOP
until the shade jogs 2x and beeps 3x.
1. Hold DOWN and STOP on controller
until the shade jogs 1x and beeps 1x.
2. Move shade to the desired lowest position
by using the UP or DOWN button.
3. To save lower limit, hold DOWN and
STOP until the shade jogs 2x and beeps 3x.
LOCK THE REMOTE ONCE THE NEW LIMITS ARE SET
11/18K2185
/
