JasonL WH0720WH Operating instructions

  • Hello! I've reviewed the assembly instructions for the jason.l Whistler 2.0 table. This document provides guidance on the necessary tools, hardware, and steps required to assemble the table, including top attachments. I'm ready to answer any questions you have about putting together your new table.
  • What tools are required for assembly?
    Do I need to use the pre-drilled holes in the table top?
    When should I fully tighten all bolts and screws?
Need help!
Call us on
1300 527 665
www.jasonl.com.au
ASSEMBLY INSTRUCTIONS
Whistler 2.0
Page 01
Note: Please ignore any pre-drilled holes or nut inserts that maybe present in your top(s). They will not match your particular
table/desk base and woods screws will be required to be screwed directly into the underside of the top.
Note: It is important to fully tighten all bolts and screws before attaching the top(s) so that the frame is suciently rigid.
Failure to do this may aect stability once the tops are attached.
Tools Required: Power screwdriver. We strongly recommend using an impact drill gun together with thread locking all screws.
Need help!
Call us on
1300 527 665
www.jasonl.com.au
ASSEMBLY INSTRUCTIONS
Whistler 2.0
Page 02
A * 1 B * 1 C * 4 (M8*70mm) D * 1 E * 1
F * 3 (M8*30mm) G * 4 H * 1 I * 9
Need help!
Call us on
1300 527 665
www.jasonl.com.au
ASSEMBLY INSTRUCTIONS
Whistler 2.0
STEP 1
Page 03
DSTEP 2
STEP 3
G
E
D
C
H
F
B
A
Need help!
Call us on
1300 527 665
www.jasonl.com.au
ASSEMBLY INSTRUCTIONS
Whistler 2.0
Page 04
STEP 4
(adding the top) is done by putting
the top upside down on the ground
first, measuring the top plate to the
edges & then drilling the screws.
Screw the table top to the base
through the following holes.
I
/