2. BARRON
  3. TLED-LVT Series 2' and 4' Linear Vaportight

BARRON TLED-LVT Series 2' and 4' Linear Vaportight Installation guide

  • Hello! I have reviewed the provided installation instructions for the TLED-LVT light. This document outlines the steps for safely mounting the light using steel cables and ensures it is done by qualified personnel. I'm ready to answer your questions about the installation process or any other aspect of the light fixture.
  • Should the AC power supply be disconnected before servicing?
    Who should perform the installation and servicing of this equipment?
    What may cause an unsafe condition?
TLED-LVT
INSTALLATION INSTRUCTIONS
800533.3948 • www.barronltg.com
20070072 REV 1 - 01/14 1
SAVE THESE INSTRUCTIONS!
READ CAREFULLY AND FOLLOW ALL INSTRUCTIONS FOR YOUR OWN SAFETY
• DISCONNECT AC POWER SUPPLY BEFORE SERVICING.
• Installation and servicing of this equipment should be performed by qualified service personnel only.
• Ensure the electricity connections conform to the National Electrical Code and local regulations if applicable.
• Do not mount near gas or electrical heaters.
• Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by
unauthorized personnel.
• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition. Any
modification or use of non-original components will void the warranty and product liability.
• Do not use this equipment for other than intended use.
INSTALLATION INSTRUCTIONS
CABLE MOUNTED
Ceiling
Screw Hole
Electric drill
Drill holes at desired location to
mount steel cables.
1
Secure fixture to the end of the
steel cables, using appropriate
hardware.
3
Steel
Cable
Connect steel cables to ceiling,
using appropriate hardware for
mounting surface.
2
Adjust to desired height, clean off
dust and debris.
4
/