2. DV8 OFFROAD
  3. INFEND-04RB

DV8 OFFROAD INFEND-04RB Installation guide

  • Hello! I have reviewed the document for the DV8 Offroad Rear Inner Fenders INFEND-04RB. This document provides instructions on how to install the inner fenders by joining each inner and outer piece together, and then fitting them in the wheel wells, also how to securely attach them using the supplied hardware. I'm ready to answer your questions about this process.
  • How many pieces of the rear inner fenders should I have?
    What do I need to do before installing inner fender?
    What should be the position of the rear rounded edge of the inner fender?
GLADIATOR REAR INNER FENDERS
(INFEND-04RB)
1. Unpack your new rear inner fenders and inspect all items. You should have two inner
pieces (left and right) and two outer pieces (left and right) and a small box of
hardware.
2. Begin by joining each inner with the corresponding outer piece with supplied
hardware. NOTE: The lip on the smaller inner piece will sit behind the outer piece as
shown in the image below.
3. Once joined, place inner fender in inner wheel well. You will have to remove most
fenders to install.
4. Line up the holes on the front and back of the inner fender first. Attach loosely.
5. The rounded edge near the rear sits behind the lip of the wheel well as shown.
6. Attach last three bolts on the bottom of the inner fender with supplied hardware.
Tighten all hardware until inner fender secure.
If you have any questions, please email us at [email protected] or
call us at 951-680-9595
/