Genaray SS-12V2 User manual

Brand: Genaray

Model: SS-12V2

Category: Stroboscopes & disco lights

Type: User manual

USER MANUAL

Square Sun

BI-COLOR SOFT LED FLOOD

Square Sun Bi-Color Soft LED Flood - USER MANUAL

THANK YOU FOR CHOOSING GENARAY

The Genaray Square Sun LED light ﬁxture provides

photographers and videographers with ultra-bright yet soft

continuous light. This 1024-LED ﬁxture can operate on AC

or battery power, and it features ﬂicker-free dimming from

100% to 10% with broad 120-degree coverage. The built-in

diffuser and the recessed placement of the LEDs within

the ﬁxture contribute to a bright and punchy light that

also has a soft wraparound quality. This design eliminates

the multiple shadows that are often associated with LED

lighting.

The Square Sun supports DMX-512 so the light’s settings

can be remotely controlled from a DMX console. It has 512

selectable channels and a 3-pin XLR output jack to daisy

chain other DMX-compatible lights.

Square Sun ﬁxtures come in a heavy-duty metal chassis

that can withstand the most demanding professional

environments. For compatibility in the studio, the

integrated yoke can be mounted to a light stand with a

baby-pin stud or a junior-pin receiver.

Square Sun™

INTRODUCTION

Square Sun Bi-Color Soft LED Flood - USER MANUAL 3

· Please read and follow these

instructions, and keep this

manual in a safe place.

· Keep this unit away from water and

any ﬂammable gases or liquids.

· Make sure the unit is powered off

when plugging it into a power source.

· Use only the correct,

recommended voltage.

· Handle the unit with care.

· Do not attempt to disassemble or

repair the equipment—doing so will

void the warranty, and Genaray will

not be responsible for any damage.

· Do not stare directly at the lights

when they are powered on.

· Clean the unit with only

a soft, dry cloth.

· Images are for illustrative

purposes only.

PRECAUTIONS

Precautions

Square Sun Bi-Color Soft LED Flood - USER MANUAL

PRODUCT

OVERVIEW

LED array /

Soft panel

Barndoors

Barndoor locking tabs

Yoke

Locking knob

Square Sun Bi-Color Soft LED Flood - USER MANUAL 5

Product overview

DMX address

Color temperature

Brightness

Gel clips

Battery plate

V-mount

release button

D-tap output

power socket

Fan

Fan on/off switch

Tilt adjustment

knob

Battery status

indicator

Dimmer/DMX knob

Power switch

Color temperature knob

LCD screen

4-pin XLR power socket

DMX output socket

DMX input socket

Square Sun Bi-Color Soft LED Flood - USER MANUAL

MOUNTING THE SS-12V2CONTENTS INCLUDE

· LED with yoke

· AC adapter

· DMX cable

· Power cord

· Barndoors

Mount the SS-12V2 on any heavy-duty

light stand with a 5/8-inch baby-pin stud,

and turn the locking knob until secure.

Remove the locking knob to mount the

SS-12V2 into a 11⁄8-inch junior pin receiver.

contents

Square Sun Bi-Color Soft LED Flood - USER MANUAL 7

The SS-12V2 can be powered

directly from an AC outlet or by a

V-mount battery (not included).

USING THE SS-12V2 WITH AC POWER

Important

The SS-12V2 is a multivoltage ﬁxture

capable of running on 100–240 V,

50/60 Hz. The included cable has a 120 V,

50 Hz (North American) plug. To use this

ﬁxture with other voltages, you must

use a plug adapter (sold separately).

Connect the AC power adapter to the

SS-12V2 with the 4-pin XLR cable, and

plug the power cable into an outlet.

The AC adapter comes in a mounting

frame that ﬁts into the V-mount. Align

the adapter with the V-mount, and

slide it into the mount until it clicks.

To remove the AC adapter, press the

V-mount release button, and slide

the adapter off of the V-mount.

USING THE SS-12V2 WITH

BATTERY POWER

The SS-12V2 is powered by

a V-mount battery.

When attaching the battery, make sure the

power switch is in the Off position, and the

ﬁxture is not plugged into a wall outlet.

A three-stud battery can be used

by connecting it to an adapter

plate (sold separately).

POWERING THE SS-12V2

instructions

Square Sun Bi-Color Soft LED Flood - USER MANUAL

OPERATING THE

SS-12V2

USING THE BARNDOORS

To attach the barndoors, place the barndoor

frame on the two lower locking tabs. Press

the top of the barndoor frame into the top

locking tabs until they click into place.

To remove the barndoors, pull the top

barndoor locking tabs to release the frame.

The battery status indicator on the rear

panel displays the remaining battery power.

4 lights (green) 80 to 100%

3 lights (green) 50 to 80%

2 lights (green) 30 to 50%

1 light (green) 10 to 30%

1 light (orange) Less than 10% (the

light will not operate)

instructions

Square Sun Bi-Color Soft LED Flood - USER MANUAL 9

USING DMX

ADJUSTING BRIGHTNESS AND

COLOR TEMPERATURE

Open the barndoors, and power the

SS-12V2 on. The LCD screen will show

the last setting that was used.

After powering on the SS-12V2, set the

brightness and color temperature by

rotating the knobs on the back of the ﬁxture.

· Color temperature can be adjusted from

3200 to 5600 K in 100 K increments.

· Brightness can be adjusted from

100% to 10% in 1% increments.

For quieter operation, turn the fan

off via the fan on/off switch.

Note

When the fan is turned off, the maximum

brightness will be capped at 80%.

The SS-12V2 supports DMX-512 so the

light’s settings can be remotely controlled

from a DMX lighting control console.

To setup DMX operation on the

SS-12V2, follow these steps:

1. Use a 3-pin XLR cable to connect a DMX

controller to the SS-12V2 DMX input jack.

2. Use the SS-12V2 DMX output jack

to connect multiple lights.

3. To set the DMX address on the

SS-12V2, press the dimmer

knob to activate DMX mode.

4. Turn the knob to select a DMX address.

Important

Make sure the DMX address on the

SS-12V2 matches the DMX console.

Press the dimmer knob again to

return to brightness control mode.

instructions

Square Sun Bi-Color Soft LED Flood - USER MANUAL

PRODUCT

SPECIFICATIONS

LED count: 1024

Color temperature: 3200 (±150) to 5600 K (±300 K)

Luminance: 3513 lx @ 3 ft.

Coverage: 120°

CRI: 96

TLCI: 96

Output power: 100 W

Working voltage: AC: 100–240 V

DC: 12–17 V

Mount: 5/8 in. baby pin convertible

to 11⁄8 in. junior pin

Dimensions: Light only: 14.8 × 14.8 × 3.3 in.

(37.7 × 37.7 × 8.5 cm)

With yoke: 17 × 21.9 × 3.3 in.

(43.3 × 55.7 × 8.5 cm)

Weight (with barndoors and yoke,

without battery): 12.1 lb. (5.49 kg)

sPecifications

ONE-YEAR LIMITED WARRANTY

This Genaray product is warranted to the original purchaser to be free from defects in materials and

workmanship under normal consumer use for a period of one (1) year from the original purchase date

or thirty (30) days after replacement, whichever occurs later. Genaray’s responsibility with respect

to this limited warranty shall be limited solely to repair or replacement, at Genaray’s discretion, of

any product that fails during normal use of this product in its intended manner and in its intended

environment. Inoperability of the product or part(s) shall be determined by Genaray. If the product

has been discontinued, Genaray reserves the right to replace it with a model of equivalent quality and

function.

This warranty does not cover damage or defect caused by misuse, neglect, accident, alteration, abuse,

improper installation or maintenance. EXCEPT AS PROVIDED HEREIN, GENARAY MAKES NEITHER

ANY EXPRESS WARRANTIES NOR ANY IMPLIED WARRANTIES, INCLUDING BUT NOT LIMITED TO

ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. This

warranty provides you with speciﬁc legal rights, and you may also have additional rights that vary from

state to state.

To obtain warranty coverage, contact the Genaray Customer Service Department to obtain a return

merchandise authorization (“RMA”) number, and return the defective product to Genaray along with

the RMA number and proof of purchase. Shipment of the defective product is at the purchaser’s own

risk and expense.

For more information, or to arrange service, visit www.genaray.com or contact us at info@genaray.com.

GG3

Genaray SS-12V2 User manual

Brand: Genaray

Model: SS-12V2

Category: Stroboscopes & disco lights

Type: User manual

Download PDF

report

Genaray SS-12V2 User manual

Genaray SS-12V2 User manual

Related papers

Other documents