Thermory/RPL Seat Cap

(4) 1/4"-20 x 2" Socket Head Screws

Fusion Advantage Seat Cap

(6) 1/4"-20 x 2" Socket Head Screws

anovafurnishings.com

888.535.5005 tel

TOOLS NEEDED:

• 3/16" Allen Wrench

or Hex Head Socket

CAN1872R - Canyon Recycled Plastic Gabion-Style 6' Bench

CAN1872T - Canyon Thermory Gabion-Style 6' Bench

CAN1872P - Canyon Fusion Advantage Steel Gabion-Style 6' Bench

BENCH COMPONENTS:

ASSEMBLY HARDWARE: All hardware is stainless steel.

ASSEMBLY:

Inspect the shipping container contents for damage and to determine that all components and hardware are present.1.

2. Lay all parts on a so work surface or on the shipping packaging to prevent damage to the nish.

3. Locate the mesh panels and place them on the work surface as shown.

NOTE: Before assembling the nuts to the bolts, it is recommended that a light oil or petroleum jelly be applied to the screw threads.

CAN1872T CAN1872P

(1) 6' or 2'

Thermory or RPL

Seat Cap

(2) End Panels

(2) 6' or 2' Side Panels(1) 6' or 2'

Fusion Advantage

Seat Cap

CAN1824PCAN1824T

(6) Plastic Feet (6) Adhesive Strips

Note: The easiest way to identify the bottom of the panels is by locating the slots, the bottoms of the panels are the only sides with slots.

Also, when applying the adhesive strips to the feet, make sure it is applied to the smooth side of the feet. It will not stick properly to the

washers through the holes of the end panel and through the

attached nuts on the side panel. Leave screws nger tight.

NOTE: Leave all screws nger tight until all panels are attached

(steps 4 - 6).

head screws and three 1/4" at washers through the holes of the

end panel and through the attached nuts on the side panel. Leave

screws nger tight.

Hammer DrillHammer

Pencil

Wire Brush

Level

Safety Glasses

Masonry Drill Bit Set

3/16", and 3/8"

Socket Set

9/16"

wire brush. This will create a clean environment for the anchor system.

Locate an anchor and adjust the nut so it is ush with the top of the

anchor to protect the threads from being damaged. Insert the anchor

into the hole.

smaller to the larger drill bits to avoid oversized holes or holes drilled too

deep. Begin with 3/16" diameter drill bit followed by the 3/8" diameter

holes with a pencil.

the anchors. Tighten all of the hardware with a ratchet and a 9/16" socket.

Repeat steps 9 - 12 until all anchors are installed.

Remove the nuts and washers o of the anchors. Align the mounting holes of

the stool or bench over top of the anchors and slide it down into place.

the seat cap frame and through the attached nuts on the

cage assembly at each end of the seat cap.

NOTE: Leave screws nger tight until all screws are placed.

Secure all screws with a 3/16" allen wrench or hex head

six 1/4"-20 x 2" socket head screws through six 1/4" at washers;

continue through the seat cap and through the attached nuts on the

side panels.

End Panel

6' Mesh Side Panel

2' Mesh Side Panel

Fusion Advantage