Hubbell Premise Wiring HWS772036-INST HJU SERIES UTP JACK Installation guide

Type
Installation guide

This manual is also suitable for

Control No. Page of
Rev. Date:
®Hubbell Premise Wiring Instruction Sheet
Hubbell Premise Wiring, HUBBELL INCORPORATED (Delaware)
14 Lord's Hill Rd, Stonington CT 06378 (800) 626-0005, Fax (860) 535-8328
www.hubbell-premise.com
Control No. Page of
Rev. Date:
HJU Series UTP Jack Termination
Instructions
HWS77203601 1 2
4 4/13/20
HWS77203601 2 2
4 4/13/20
Hubbell Premise Wiring, HUBBELL INCORPORATED (Delaware)
23 Clara Dr Suite 103 Mystic, CT 06355 (800) 626-0005, Fax (860) 535-8328
www.hubbell-premise.com
Remove 1" (25mm) of jacket
from cable. (Figure 2)
Place wire manager
on cable. (Figure 1)
1
2
3
4
5
6
Figure 1 Figure 2
Trim wire separator from cable
and insert wires into the slots
in the wire manager based
on the desired color code.
(T568A/T568B) (Figure 3)
Figure 3
Figure 4
Figure 5
Trim wires ush to wire
manager. The wires should
not protrude more than
1/64" (.5mm) from wire
manager. (Figure 4)
Line up arrows on
wire manager with
arrows on jack.
Note: The brown
pair will always go
towards the Cobra
Lock. (Figure 5)
With wire manager in
place, rotate termination
jaws; the jaw opposite the
Cobra Lock should rotate
rst. (Figure 6)
Squeaze the termination jaws
closed until the Cobra Lock
latches engage to complete the
termination. (Figures 7, 8)
To disassemble the jack, place
a small at screw driver into
the slots and rotate to pry
open the Cobra Lock latches.
(Figure 9)
Cobra Lock
Arrow
located on
side with
brown pair.
Arrows
Figure 6
Figure 7 Figure 8
Figure 9
Note: Accepts
24 to 22 AWG
conductors. Max
cable diameter
.31" (8mm).
  • Page 1 1

Hubbell Premise Wiring HWS772036-INST HJU SERIES UTP JACK Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI