meitav-tec FMH-24-C2-3S-IR Product information

Brand
meitav-tec
Model
FMH-24-C2-3S-IR
Type
Product information
FMH/24/C2/3S/IR
Date:
Title:
No.Revision Date File name: FMH-24-C2-3S-IR-rev1.vsd
Print name:
Checksum: 891D
Software name: FHC23S02
Drawn: P.Rechtman
Checked: O.Volovitch
Approved: V.Rabinovitch
FMH/24/C2/3S/IR
Ert300/IR
OUT-ERT300/5/24
RE1
3
2
1
C
R
cool 1
medium
low
high
24Vac
fan speeds
88
Cool
Fan
Hi
Med
Low
On
Off
Aux
oC
Set
On/Off
Mode
Fan
Set delay for compressor and offset
Set temperature to 10oC.
Press and hold the MODE button until "30" appear on display.
Using the "+" and "-" buttons select with or without 3 minutes delay for compressor (“3”
flashing-with delay, ”0" flashing-without delay).
Press the MODE button again - a number between -6…+6 appear.
Using the "+" and "-" buttons set the offset (range -6oC…+6oC).
(The offset is used for calibration of the measured tmperatre).
Press the MODE button again to return to normal display mode.
Attention: All setting will be saved to EEPROM!
Fan on/Auto fan setting:
Press and hold (3 sec.) the FAN button to switch between “fan on” and “auto fan”.
In “fan on” mode the word “FAN” will appear on display.
In “auto fan” mode the word “FAN” will not appear on display.
Timer indication:
If daily timer active – the word "Aux" will appear on display. .
After break of power, “AUX” will flash and the timer will not work.
Technician Settings:
IR (Option)
cool 2
RE2
Dec. 15, 2005
meitav-tec
Tel: +972-3-9626462
Fax: +972-3-9626620
e-mail: support@meitavtec.com
  • Page 1 1

meitav-tec FMH-24-C2-3S-IR Product information

Brand
meitav-tec
Model
FMH-24-C2-3S-IR
Type
Product information
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents