2. Computers & electronics
  3. Telecom & navigation
  4. Mobile phones
  5. Car kits
  6. Legrand
  7. Medium Concrete Enclosure Trim Kit - F7756

Legrand Medium Concrete Enclosure Trim Kit - F7756 Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Legrand Medium Concrete Enclosure Trim Kit - F7756 Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
INSTRUCTION/INSTALLATION SHEET
Medium Concrete Enclosure Trim Kit
IS-0413 REV. O
©Copyright 2008 by On-Q/Legrand All Rights Reserved. Page 1 of 1
1. Introduction
The On-Q/Legrand Trim Kit (P/N F7756) for Medium Concrete Enclosures
(P/N 7507) consists of a Wing-style Module Mounting Bracket and
associated hardware.
2. Installation
The Trim Kit is typically installed after the concrete enclosure has been
installed and the concrete has been poured.
NOTE: To complete the installation you will need an 11/32” socket
wrench or nut driver.
A. Locate both pairs of threaded mounting studs which stick out from
both sides of the enclosure (see Figure 1).
B. Hand thread all four supplied hex nuts onto the threaded mounting
studs four to five full turns.
C. Place the Wing Bracket into position over the threaded mounting
studs.
Note: If the Wing Bracket is correctly positioned, the studs will
prevent the bracket from being moved up or down (see Figure 2).
D. Utilizing an 11/32” socket wrench or nut driver, tighten all four hex nuts
firmly to ensure the Wing Bracket is tightly held in place.
E. Installation is now complete.
Figure 1
Concrete
Enclosure
Figure 2
Threaded
Mounting
Studs
Wing Bracket
/