Legrand Concrete Enclosure Covers - F8030 & F8032 Installation guide

Concrete Enclosure Covers - F8030 & F8032
Legrand
Brand
Legrand
Model
Concrete Enclosure Covers - F8030 & F8032
Type
Installation guide

This manual is also suitable for

INSTRUCTION / INSTALLATION SHEET
Concrete Enclosure Covers
IS-0338 Rev. O
301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
©Copyright 2005 by On-Q/Legrand All Rights Reserved. Page 1 of 1
1. Introduction
On-Q/Legrand Concrete Enclosure Covers are attractive hinged metal covers for trim enclosures used in
concrete construction (see
Figure 1). They are available in two sizes:
Size Part # Holes For use with Enclosure:
Large F8032 6 Large Rough-In Enclosure For Concrete
Construction 36"x19" (P/N F7506)
Small F8030 4 Small Rough-In Enclosure For Concrete
Construction 20"x14" (P/N F7505)
On-Q/Legrand Concrete Enclosure Covers mount flush with the wall. They are
slightly larger than the enclosures they cover and hide drywall rough edges, resulting
in a polished, finished look. A hinged door with latch gives the homeowner access to
the On-Q/Legrand components housed inside.
2. Description
Each cover is made of sturdy 18 gauge, white powder coated steel and ships with an
accessory bag containing the necessary screws, star washers and cover latch. The large
cover requires 6 screws and washers (see Figure 2); the small cover requires 4 screws and washers.
Figure 1
Hardware Included
Star Washers
Screws
Enclosure
Wall
Enclosure Cover
Figure 2
3.
Installation
NOTE: Install the Cover AFTER the enclosure and all modules have
been terminated and verified as working properly.
NOTE: You will need a Phillips head screwdriver.
A. Place star washers over cover screws
Locate the star washers and screws that are included with the cover.
Place one star washer over each of the screws.
B. Lift cover into place
While utilizing the help of another person, lift and align the cover into
place and make sure that each of the mounting holes in the cover are
properly aligned with the holes in the face frame of the enclosure
(see Figure 3).
Figure 3
C. Firmly fasten the cover to the enclosure
Insert and firmly tighten each of the screws to attach the cover to the enclosure. In each case, make
sure that the star washer is located between the cover and the screw head.
  • Page 1 1

Legrand Concrete Enclosure Covers - F8030 & F8032 Installation guide

Concrete Enclosure Covers - F8030 & F8032
Legrand
Brand
Legrand
Model
Concrete Enclosure Covers - F8030 & F8032
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents