Coats Kit 8183491, Bump-n-Roll Operating instructions

Brand: Coats

Model: Kit 8183491, Bump-n-Roll

Type: Operating instructions

Manual Part No.: 8183499

Revision Date: 1/99

1601 J. P. Hennessy Drive, LaVergne, TN USA 37086-3565 615/641-7533 800/688-6359

HENNESSY INDUSTRIES INC. Manufacturer of AMMCO®, COATS®and BADA®Automotive Service Equipment and Tools.

Installation Instructions

Operating Instructions

Coats

Bump-n-Roll

Part No. 8183491

2 • COATS Bump-n-Roll

Installing your new “Bump-n-Roll”

1. Remove the Torx T40 screws from the lower

front bead loosener pad on your 5030, 5050,

5060, or 6060 tire changer and remove the

bead loosener pad.

NOTE: Clean off any dirt and/or debris that

may have accumulated around the bead

loosener pad so that the Bump-n-Roll

assembly has an even surface for mounting.

2. Place the Bump-n-Roll assembly on the floor

next to your COATS tire changer and line up

the holes in the Bump-n-Roll assembly with the

screw holes in the side of the tire changer

where the bead loosener pad was removed.

On 5030 machines, line up two (2) holes at

front of the Bump-n-Roll assembly and install

the extension plate under the upper flange of

the Bump-n-Roll assembly with the two (2) 1/4-

20 screws supplied. (See Parts Listing)

3. Replace the bead loosener pad (over the

Bump-n-Roll bracket) with the four (4) new

screws supplied with the Bump-n-Roll

accessory. You are now ready to “Bump-n-

Roll”. (Discard excess hardware)

COATS Bump-n-Roll • 3

Using your new “Bump-n-Roll”

Parts List — “Bump-n-Roll”

With the new Bump-n-Roll, encountering a stubborn

bead will be an easier process. When the bead is

loosened the first time (with the valve stem at the 2

o’clock position) and the user finds it is necessary to

loosen the bead at another location; hold the bead

loosener shoe away from the tire with one hand and

then roll the tire forward with adequate force into the

Bump-n-Roll apparatus and the tire will spin to an

alternate location for additional bead loosening.

In the past when a stubborn bead was encountered,

the user had to roll the tire back away from the bead

loosener , release the bead loosener handle, pick up

the tire and spin it the desired amount, grab the

bead loosener handle, open it to the desired width,

and roll the tire back into the bead loosening area.

When servicing tires on

wheels which have the old

style strap-on pressure

sensors; take care not to damage the sensor.

Sensor is located directly opposite the valve stem.

PART

ITEM NO. DESCRIPTION

1 8183495 Bracket—Bump-n-Roll

2 8183493 Tube, 1.625 x .156 x 8.938

3 8183492 Shaft—3⁄4" x 10.063

4 8183494 Bearing—Nylon

5 8101001 3⁄4" Snap Ring

6 8183375 Decal, Bump-n-Roll

7 8183768 Extension—5030 Only

8 8106301 1⁄4-20 Self Tapping Screw

CAUTION

Coats Kit 8183491, Bump-n-Roll Operating instructions

Coats Kit 8183491, Bump-n-Roll Operating instructions

Coats Kit 8183491, Bump-n-Roll Operating instructions

Related papers

Other documents