2. Coats
  3. Custom Wheel-er Protector Set

Coats Custom Wheel-er Protector Set Operating instructions

  • Hello! I'm your chat assistant, and I've reviewed the document about the COATS Custom Wheel-er Protector Set. This document provides instructions on how to install and use the protectors to prevent rim damage during tire servicing. I am ready to answer any questions about this device and its use based on the information provided in this document.
  • When should I use the protectors?
    What should I use the COATS Custom Wheel-er adapter part no. 8105750 for?
    What can happen if I ratchet the Upper Bead Loosener after the upper bead is loosened?
8107404 01 07/02 © COPYRIGHT 1995 HENNESSY INDUSTRIES AND COATS ALL RIGHTS RESERVED PRINTED IN U.S.A.
COATS Custom Wheel-er Protector Set
Instructions for the Prevention of Rim Scratches
Caused by the Combo Tool
Extreme care must be exercised when servicing mag or style steel wheels to prevent damage. For pro-
tection against breakage of mag wheels, the coats custom wheel-er adapter part no. 8105750 must be
used. Always, when servicing any tire, use coats rubber lubricant to add to life of machine and protectors.
Use protectors only when servicing mag, aluminum, or style steel wheels. Above all, take your time and
inspect the operation carefully.
COATS, Inc. • Hennessy Industries
1601 J.P. Hennessy Drive, LaVergne, TN 37086-3565
(800) 688-6359 • (615) 641-7533 • (615) 641-5104 FAX
www.ammcoats.com
1. Install COATS Custom Wheel Protectors on the
Combination Tool & Upper Bead Loosener Nose as
shown in Photo 1 & 2, loosening Upper Bead Breaker
in normal manner. Do not ratchet Upper Bead
Loosener after upper bead is loosened. This could
cause serious damage to Machine, Upper Bead
Loosener Protector and Wheel.
2. Demount tire in the usual manner. Make certain
Plastic Protector is positioned to completely cover the
end of the Tool. See Photo 3 and refer to the machine
Operating Instructions.
3. Mount tire in the usual manner. Make certain
Plastic Protector is positioned to completely cover the
end of the Tool. See Photo 4 and refer to the machine
Operating Instructions.
/