ASSEMBLY AND INSTALLATION
INSTRUCTIONS
181017
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
T0450
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
Hardware Package (inculded):
Turn off the power at fuse or circuit
box.
Installation Steps
1. Attach two fixture mounting screws (D) to the
mounting strap (A), and then secure it with two
lock nuts (F). Adjust the length of the fixture
mounting screws (D) if necessary.
2. Attach the mounting strap (A) to the outlet box
using two mounting screws (B).
3. Pull out the outlet wires and the house grounding
wire from the outlet box. Make wire connections
using the wire connectors (C):
---The black (hot) wire from the fixture to the black
(hot) wire from the power source.
---The white (neutral) wire from the fixture to the
white (neutral) wire from the power source.
---Attach the fixture grounding wire to the mounting
strap (A) with the green grounding screw (E).
Then connect it to the house grounding wire
with the wire connector (C).
Carefully put the wires back into the outlet box.
4. Attach the pan to the mounting strap (A) by inserting
two fixture mounting screw (D) heads into the hole
slots, and rotate the pan until it locks in place.
Then secure the ball nuts (G). (See Fig.1)
House Grounding Wire
Outlet Box
Wire Connector (C)
Lock Nut (F)
Mounting Strap (A)
Green Grounding Screw (E)
Mounting Screw (B)
Fixture Mounting Screw (D)
Fixture Grounding Wire
Pan
Hex Nut (I)
Hex Nut (I)
Metal Pad (J)
Metal Pad (J)
Rubber Pad (K)
Rubber Pad (K)
Fixture body
Socket
Threaded Pipe (H)
Glass Assembly
Bulb Type A Max. 60W
(not included)
Finial (M)
Decorative Cap (L)
Green Grounding
Screw (E)
Lock Nut (F) Ball Nut (G)
Fixture Mounting
Screw(D)
Mounting Screw (B)
Wire Connector (C)
Mounting Strap (A)
Hole Slot
Socket
Ball Nut
Fig.1
181017
A: 13"
B: 6"
The following parts are available for re-order if damaged or missing.
Turn on the power at fuse or circuit
box.
5. Install bulbs (not included). See relamping label at socket area or packaging for maximum allowed wattage.
6. Slip the glass assembly up through threaded pipe (H) and secure it with a hex nut (I) ,metal pad (J) , rubber pad (K),
Slide the decorative cap (L) up to glass assembly, then with the rubber pad (K), metal pad (J), hex nut (I), end cap
and secure it with the finial (M).
Spare Parts List:
Mounting Hardware
6013MM(1 SET)
Mounting Hardware
6014MM(1 SET)
Decorative Cap (L)
Finial (M)
Metal Pad (J)
Rubber Pad (K)
Threded Pipe (H)
Hex Nut (I)
Green Grounding
Screw (E)
Lock Nut (F) Ball Nut (G)
Fixture Mounting
Screw(D)
Mounting Screw (B)
Wire Connector (C)
Mounting Strap (A)
/
