Xerox 230 LP Installation guide

Type
Installation guide

Xerox 230 LP, a versatile printing solution, offers efficient network connectivity options. With Token Ring interface capabilities, it seamlessly integrates into Token Ring networks, allowing for high-speed data transfer and reliable printing. The printer's extensive menu system, accessible via its intuitive control panel, provides easy navigation and configuration options. Additionally, the device boasts a range of features, including speed settings, source routing options, and password protection, ensuring secure and efficient printing operations.

Xerox 230 LP, a versatile printing solution, offers efficient network connectivity options. With Token Ring interface capabilities, it seamlessly integrates into Token Ring networks, allowing for high-speed data transfer and reliable printing. The printer's extensive menu system, accessible via its intuitive control panel, provides easy navigation and configuration options. Additionally, the device boasts a range of features, including speed settings, source routing options, and password protection, ensuring secure and efficient printing operations.

7+('2&80(17&203$1<

DC230LP Token Ring
®
Quick Install
Page 1 of 2
DC230LP System Administration Guide,
Network Installation and Troubleshooting
.
f)
Press [Enter]. displays.
2. Access the Token Ring menus:
a)
Press []. displays.
b)
Press []. displays.
c)
Press []. displays.
3. Enable Token Ring:
a)
Press []. displays.
b)
Press []. displays.
c)
Press []. displays.
d)
Press [Enter]. **SAVED** displays
momentarily, followed by
.
System Admin
>
Port Setup
>
Parallel Port
>
Token Ring
>
Enablement
Disabled
>
Enablement =
Disabled *
Enablement =
Enabled
Enablement
Enabled
>
4. Set the Token Ring Port Speed:
Note: Token Ring Port Speed settings available
are
Auto, 4Mbps, and 16Mbps
.
a)
Press [] until
displays.
b)
Press []. displays.
c)
Press [] until the required setting
displays.
d)
Press [Enter]. **SAVED** displays
momentarily, followed by
.
5. Select the Token Ring Source Routing:
Note: Token Ring Source Routing settings
available are
Single, All, and None
.
a)
Press [] until
displays.
b)
Press []. displays.
Speed
(current entry)
>
Speed =
(current entry) *
Speed
(your entry)
>
Source Routing
(current entry)
>
Source Routing =
(current entry) *
Over
Installation Requirements:
The Token Ring card must be inserted face
down
to obtain connectivity.
Before Installation:
This installation procedure assumes that you
know how to navigate through the menu system
on the DC230LP Control Panel. Refer to the
quick reference card,
Using the Menu System,
(701P96834) for assistance.
Perform the following procedure if Token Ring
will be selected as the Interface for the network.
1. Access the System Administration menus:
a)
Press [Online] to take the printer off
line. displays.
b)
Press [Menu]. displays.
c)
Press [], then press [] or [] until
displays.
d)
Press []. displays.
e)
Use the [] and [] keys to enter
[2222].
Note: 2222 is the factory default password and
may be changed to suit your needs. Refer to the
Printer Off Line
Main Menu
>
System
Administration
>
Enter Password
>
For assistance, contact your local Xerox Customer Support Center:
USA: 1-800-821-2797 Canada: 1-800-939-3769
7+('2&80(17&203$1<

DC230LP Token Ring
®
Quick Install
Page 2 of 2
7. Check the settings on the Configuration
Report under
Port Setup
against the
required settings.
8. Refer to the Quick Install card for your
environment and perform the network
installation at the DC230LP.
Additional information on the Token Ring instal-
lation and setup can be found in the
DC230LP
System Administration Guide, Network Installa-
tion and Troubleshooting
.
c)
Press [] until the required setting
displays.
d)
Press [Enter]. **SAVED** displays
momentarily, followed by
.
6. Save all settings:
a)
Press [Online].
displays.
b)
Press [Enter].
displays. The DC230LP will reboot,
save the settings entered, and print a
Configuration Report in approximately
3 minutes.
Source Routing
(your entry)
>
Reset Required
Press ENTER key
>
Warming Up
Please Wait . . .
>
©1998 Xerox Corporation
701P98459 Version 1.0, 5-98
  • Page 1 1
  • Page 2 2

Xerox 230 LP Installation guide

Type
Installation guide

Xerox 230 LP, a versatile printing solution, offers efficient network connectivity options. With Token Ring interface capabilities, it seamlessly integrates into Token Ring networks, allowing for high-speed data transfer and reliable printing. The printer's extensive menu system, accessible via its intuitive control panel, provides easy navigation and configuration options. Additionally, the device boasts a range of features, including speed settings, source routing options, and password protection, ensuring secure and efficient printing operations.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI