Rugged Ridge 13510.16, 13510.09 Installation guide

  • Hello! I have analyzed the provided document regarding the OMIX-ADA Hardtop Quick Release Kit, models 13510.15 and 13510.16. The instructions detail the process of installing the quick-release components, including knobs, pins, and catches. I am now familiar with the installation steps and the components included, which differ slightly between the 2-door and 4-door kits. Feel free to ask me any questions about the installation process or the specific parts.
  • What tool is needed to remove the hardtop screws?
    Which kit includes Quick Release Pin, Pin Catch, Button Head Bolt, Flat Washer, and Oversized Flat Washer?
    What should be done to prevent loss of hardware during Pin Catch installation?
Copyright © 2017 Omix-Ada®, Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]
Elite Hardtop Quick Release Kit patent pending
Page 1/3
Part # 13510.15
13510.16
OMIX-ADA® TECHNICAL SUPPORT
PHONE: M-F 8am - 5pm EST 1-800-449-6649 | EMAIL: [email protected]
FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com
1. Elite Hardtop Knob (6)
2. Quick Release Pin (2)
3. Pin Catch (2)
4. Button Head Bolt (2)
5. Flat Washer (2)
6. Oversized Flat Washer (2)
Components
NOTE: Components 2 - 6 only included with 13510.16 - Elite Hardtop Quick Release Kit; 4 Door
1
23
4 5
6
Copyright © 2017 Omix-Ada®, Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]
Elite Hardtop Quick Release Kit patent pending
Page 2/3
3. Install Pin Catch and Flat Washer inside of hole for
hardtop screws. Place Oversized Flat Washer over
Button Head Bolt and screw into Pin Catch. Button
Head Bolt goes through xed nut for hardtop bolt.
2. Remove freedom panels and remove two
remaining hardtop screws using T-40 Torx driver.
1. Using T-40 Torx driver, remove six hardtop screws
along tub rail and install Elite Hardtop Knobs.
NIf installing 13510.15 - Elite Hardtop
Quick Release Kit; 2 Door, installation
is complete.
Tape over opening at top of
seat belt tower to prevent loss of
hardware if dropped.
NOTICE
NOTICE
Copyright © 2017 Omix-Ada®, Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]
Elite Hardtop Quick Release Kit patent pending
Page 3/3
5. Reinstall freedom panels.
4. While pushing down on hardtop, insert Quick
Release Pin in Pin Catch. Fold ring on Quick Release
Pin over top of Pin Catch.
/