2. Rugged Ridge
  3. 11348.02

Rugged Ridge 11348.02 Installation guide

  • I have reviewed the installation instructions for the Bug Deflector. This document outlines the necessary steps for securely attaching the deflector to your vehicle's hood using screws, plugs, washers, and adhesive tape. I'm ready to answer any questions you might have about the installation process or the included components.
  • What are the contents of the package?
    How many holes in hood need to use during installation?
    Can I use power tools to install?
    How to install bug deflector?
Copyright © 2013 Omix-Ada®, Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]
Page 1/1
11348.02
Bug Deflector
OMIX-ADA® TECHNICAL SUPPORT
PHONE: M-F 8am - 5pm EST 1-800-449-6649 | EMAIL: [email protected]
FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com
Contents:
• Bug Deector (1)
• Screw Plugs (2)
• Phillips Head Screws (2)
• Washers (2)
2. Remove red protective backing from double sided
tape. Install bug deector. Secure with two washers and
two screws into previously plugged holes. Press rmly on
taped areas and hold for 60 seconds.
NOTE: Do not use power tools to install this product. Do
not overtighten.
1. Clean and open hood. Test t bug deector centrally
on hood. Note (2) holes in hood cooresponding with two
slots in bug deector. Remove bug deector. Insert plastic
screw plugs into holes previously noted.
/