Rugged Ridge Rear Seat Organizer Installation guide

  • I have reviewed the installation instructions for the Rugged Ridge Rear Seat Organizer for JK models. This document outlines how to install the organizer, including steps to fit it onto the rear seat cup holder and a specific step for four-door models with Rugged Ridge floor liners. I am ready to answer any questions you have regarding installation or the product itself.
  • What is the first step for installation?
    When do you need to cut the bottom of the organizer?
    Is there a risk during the recess cut?
460 Horizon Drive #400 | Suwanee, GA 30024 USA | www.omix-ada.com | Copyright © 2013 Omix-Ada®, Inc.
Page 1/1
1. Place/push rear seat organizer onto the rear seat cup holder. Make
sure factory rubber sleeve is installed in cup holder.
2. ONLY If you own a four door Rugged Ridge Floor liner(12975.01/.03),
nd recess on the underside of the rear seat organizer. Using a razor
blade, cut out the recess as shown.
3. Rear seat organizer is now secured and ready for use.
13551.53 (Tan 4 Door JK)
13551.51 (Black 4 Door JK)
13551.52 (Tan 2 Door JK)
13551.50 (Black 2 Door JK)
REAR SEAT ORGANIZER JK 2011+PATENT PENDING
NOTICE Illustrations and product will vary from 2 door to 4 door JK’s.
Contents:
Rear Seat Organizer
OMIX-ADA® TECHNICAL SUPPORT
PHONE: M-F 8am - 5pm EST 1-800-449-6649 | EMAIL: [email protected]
FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com
Cutting/Sharp Edge Hazard: Cut carefully using gloves and eye protection.
CAUTION
!
/