2. Rugged Ridge
  3. Billet Aluminum Transfer Case Shift Knob

Rugged Ridge Billet Aluminum Transfer Case Shift Knob Installation guide

  • Hello! I've reviewed the installation instructions for the Rugged Ridge JK Billet Aluminum Transfer Case Shift Knob. The document outlines the steps for replacing your old shift knob, including removal, installation, and verification of proper fit. I'm ready to help answer your questions about the installation process and the product.
  • What should I do before starting the installation?
    What is the first step in removing the old shift knob?
    How do I ensure the new shift knob is installed correctly?
Rev. 8/11 Page 1 of 1 SB
PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE YOU BEGIN.
Step 1. Removing the factory transfer case shift knob. Set the
emergency brake. Start the vehicle and place the transfer case
into the neutral position. Turn vehicle o. Apply upward pulling
force to disengage knob from shaft.
Step 2. Install the new shift knob onto the post. Ensure the shift pattern
is orientated correctly.
Step 3. Tighten the set screw. Start the vehicle and cycle transfer case
into all modes to verify a tight t. Place transfer case into normal
operating position. Test handle to ensure proper function before
operating vehicle.
11421.03 Brushed
11422.03 Black
JK Billet Aluminum Transfer Case Shift Knob 07-10
Contents: Shift Knob (1)
For Technical Assistance Contact:
Omix-Ada Tech Support
Phone: 1-800-449-6649
Email: [email protected]
Web: www.Omix-Ada.com
Copyright Omix-Ada 2011
/