5019 418 33002
DL 3352 - E 260/F
1. Control panel.
2. Grease filters (behind the extractor grille).
3. Lighting unit.
4. Grease filters surround.
Replacing bulbs
1. Disconnect the electrical power supply.
2. Remove the extractor grille.
3. Remove the burnt-out bulb.
Replace using 40 W max E14 bulbs only.
4. Refit the extractor grille.
Removing and renewing or cleaning the
grease filter
1. Disconnect the electrical power supply.
2. Remove the extractor grille
(turn the side knobs 90°).
3. Remove the dirty grease filter (the grease filter is fixed
to the extractor grille with clips which unfasten to
allow extraction of the filter).
4. After the grease filter has been replaced or cleaned
(depending on model), refit the parts in reverse
order, making sure the entire extraction surface is
covered.
Fitting or renewing the carbon filter
1. Disconnect the electrical power supply.
2. Remove the extractor grille.
3. If the carbon filter is already fitted and needs
renewing, turn anti-clockwise until it unlocks.
4. If the carbon filter is not mounted, mount the
filters over the motor protection grille and turn the
carbon filter clockwise.
5. Refit the extractor grille.
CONTROL PANEL
A. Speed selector switch.
B. Light switch.
2
3
1
4
B
A
me
um amount o
steam and fumes
large amount
of steam and
fumes
small amount of steam
and fumes
FGB
41833002.fm5 Page 3 Friday, June 1, 2001 5:51 PM
