Dynomax 39537 Installation guide

  • Hello! I'm a chat assistant, and I've reviewed the installation instructions for the Dynomax Axle-back Pipe Kit 39537. This document provides the necessary steps to install the pipe on Jeep Wrangler JL and Wrangler Unlimited JL models, including the removal of the old muffler and the installation of the new tail pipe using a clamp. I'm here to help you with any questions you have about this product or the installation process.
  • What should I do before beginning the installation?
    What should I use to help remove the O.E. muffler assembly?
    What parts are included in the kit?
2701 N. Dettman Rd.
Jackson, MI 49201
INSTALLATION INSTRUCTIONS FOR
DYNOMAX AXLE-BACK PIPE KIT: 39537
2019-2018 Jeep Wrangler JL,
Wrangler Unlimited JL 2.0L Turbo, 3.6L V6
DANGER WARNING: Should the purchaser decide to install any exhaust
product at home, be warned that passenger car or light duty truck/van
bumper jacks are intended for emergency use only. The use of frame
contact jack stands, in conjunction with a floor jack as main support, is
highly recommended to minimize accidental dropping of a vehicle during
the installation process.
NOTE: Please read all instructions before beginning the installation.
1. Remove the O.E. muffler assembly from behind the OE intermediate
pipe. Lubricate the rubber isolators with WD-40, or a similar product,
to aid in removal of the rod hangers.
2. Install DynoMax tail pipe 73018. Slightly tighten the 2 ½” clamp that
connects this pipe to the outlet of the OE intermediate pipe. Insert
the rod hanger.
3. Align the pipe and fully tighten the clamp.
KIT CONTAINS:
(1) 73018 pipe
(1) 36438 band clamp
(1) Dynomax sticker
(1) Instruction sheet
Form: 82527575
09/2019
39537 SYSTEM DIAGRAM
2Z\x"
Clamp
73018
/