2. Dynomax
  3. 39536

Dynomax 39536 Installation guide

  • Hello! I'm your chat assistant, and I've reviewed the provided installation instructions for the Dynomax Super Turbo Axle-Back Kit. This document covers the installation process for the 39536 kit, including the 53992 muffler and 36472 tips, on Jeep Wrangler models. The instructions emphasize safety and provide a step-by-step guide. I'm ready to answer your questions about the installation or the product itself.
  • What should I use to lubricate the rubber isolators?
    What is the first step in the installation process?
    What is included in the kit?
    What type of vehicle is this system for?
2701 N. Dettman Rd.
Jackson, MI 49201
INSTALLATION INSTRUCTIONS FOR
DynoMax Super Turbo Axle-Back Kit: 39536
2018 Jeep Wrangler, Wrangler Unlimited 2.0L Turbo, 3.6L
DANGER WARNING: SHOULD THE PURCHASER DECIDE TO INSTALL
ANY EXHAUST PRODUCT AT HOME, BE WARNED THAT PASSENGER
CAR OR LIGHT DUTY TRUCK/VAN BUMPER JACKS ARE INTENDED FOR
EMERGENCY USE ONLY. THE USE OF FRAME CONTACT JACK STANDS,
IN CONJUNCTION WITH A FLOOR JACK AS MAIN SUPPORT, IS HIGHLY
RECOMMENDED TO MINIMIZE ACCIDENTAL DROPPING OF A VEHICLE
DURING THE INSTALLATION PROCESS.
NOTE: Read all instructions before starting any work.
1. RemovetheO.E.muerassemblyfrombehindtheOEintermediate
pipe.LubricatetherubberisolatorswithWD-40,orasimilarproduct,
toaidinremovalofthemetalrodhangers.
2. InstallDynomaxSuperTurboSSmuerassembly53992.Slightly
tightenthe2½”clampthatconnectsthismuertotheoutletoftheOE
intermediatepipe.Insertbothrodhangers.
3. InstallDynomaxSStips36472.Seethesystemdiagramontheback
pageoftheseinstructions.
4. Beginningattheinletend,alignthemuerassemblyandfullytighten
alltheclamps. KIT CONTAINS:
(1)53992muer
(2)36472tipw/clamp
(1)36438bandclamp
(1)Dynomaxsticker
(1)Instructionsheet
Form:82446175
6/2017
39536 SYSTEM DIAGRAM
Form:82446175
6/2017
53992
36472
36472
2Z\x"
Clamp
2C\v"
Clamp
2C\v"
Clamp
/