2. FLEXCO
  3. Segmented Transfer Plate

FLEXCO Segmented Transfer Plate Operating instructions

  • Hello! I'm your chat assistant. I've reviewed the Assembly Guide for the FLEXCO Kit 101808 Transfer Plate Bracket. This guide provides instructions for installing the bracket on conveyors, especially in situations where there's limited structure. The document includes steps for determining the bracket location, measuring width, and secure installation using fasteners. I'm ready to answer any questions you have about the installation or features of this kit.
  • What is Kit 101808 intended for?
    What does Kit 101808 contain?
    What should I reference for full installation details?
Kit 101808 is intended for STP installations on conveyors where there is no structure available or where there is limited installation area.
For full installation details, reference the Segmented Transfer Plate IOMs X4064 and & X6041. Kit 101808 contains one pair of brackets and
installation hardware.
STP Assembly Guide (Kit 101808) for Wide Flange
Transfer Plate Bracket Installation
Instructions for Installation
2525 Wisconsin Avenue • Downers Grove, IL 60515-4200 • USA
Tel: (630) 971-0150 • Fax: (630) 971-1180 • E-mail: info@flexco.com
Visit www.flexco.com for other Flexco locations and products.
©2021 Flexible Steel Lacing Company. 09-27-21. For Reorder: 101899
1. Determine location of transfer plate. 2. Measure the inside structure width to determine the
placement of the bracket.
3. Insert support bar and brackets as per X4064. Use the
adhesive backing to place the brackets into position.
4. Secure the bracket with at least four fasteners.
Aligned
drive
Direction of travel
Aligned
Direction of travel
5. Assemble the mounting bar, two pairs of center segments,
and a mounting bracket on each end of the bar as per X4064.
/