FLEXCO Inverted Long Drop Mount Bracket Operating instructions

Hello! I'm here to help you with your questions about the Inverted Long Drop Mount Bracket (Kit 108821). I've carefully reviewed the provided installation instructions, which detail the proper assembly and mounting of the brackets, including the use of shims for accurate positioning and drilling to secure the assembly to the conveyor side wall. Feel free to ask if you have any specific questions about the installation or the features of this mount bracket.
What is Kit 108821 intended for?

What does Kit 108821 allow?

What applications is Kit 108821 recommended for?

What size drill bit is required?

Reference Segmented Transfer Plate IOM (X4064) for full installation details. This sheet is only to guide the installation of the optional

mounting bracket.

NOTE: Kit 108821 is intended for STP installations where access to the underside of the conveyor structure is extremely limited. Kit 108821

offers the option to install the STP brackets directly on the side panels above the transfer where there is insufficient space or access below

the conveyors to install the standard STP brackets. Reference Segmented Transfer Plate IOM X4064 for full installation details. Kit 108821 is

recommended for airport operations (baggage handling, check in, X-Ray tunnels) and logistics applications (parcel, package handling) where a

low-profile conveyor is required.

Inverted Long Drop Mount Bracket (Kit 108821)

Instructions for Installation

Inverted Long Drop Mount Bracket (Kit 108821)

Bolts (4)

Long Drop

Mount Brackets (2)

Flange Nuts (4)

Shims (8)

2. Identify the bracket slots to be used

for mounting and verify that there are no

obstructions behind the structure. Use a

center punch to mark the holes and seat the

drill bit.

3. Drill the first hole with a 11/32" (9mm)

drill bit. Fasten the bracket using the included

carriage bolts and serrated flange nuts. Repeat

for second hole and opposite bracket.

4. Once all fasteners are started and final

clearance between belt and segments is

confirmed, tighten all fasteners until the

bracket seats tight against the conveyor

side wall. Refer to IOM X4064 to finish the

installation.

Visit www.ﬂexco.com for other Flexco locations and products, or to ﬁnd an authorized distributor.

1. Measure interior distance between side walls

and cut bar to length following instructions

found in X4064. Install pairs of plastic

segments along the length of the steel bar,

trimming segments as necessary, and one

Inverted Long Drop bracket on each end of

the bar. Place the full assembly into the gap,

making sure everything is properly aligned

between the rollers. Be sure to use shims to

set the correct position of the transfer plate

assembly, following the instructions in X4064.