Connectivity Brackets • Setup Guide

This guide provides instructions for assembling and installing the following accessories:

• Cable Bracket Kit — Quad

• Retractor Bracket Kit — Double

Connectivity brackets allow users to configure the Cable Cubby enclosure with the power

module installed at the center and two cable pass-through modules on the sides (see the image

at the bottom of this page), two retractor assemblies on the sides (see Retractor Bracket Kit -

Double on the next page), or a combination of the two.

NOTE: See the Extron website for a list of compatible brackets to suit the enclosure.

3

Secure the grommet

plate on the bracket,

using four of the

provided module

screws.

Snap the included hole plugs

into any unused holes

Connectivity Brackets • Setup Guide (Continued)

Retractor Bracket Kit - Double

• For instructions on installing the power module, see the setup guide for the enclosure.

• For instructions on mounting the retractors in the horizontal orientation, see the Cable

© 2017-2018 Extron Electronics — All rights reserved. All trademarks mentioned are the property of their respective owners.