Connectivity Brackets • Setup Guide
This guide provides instructions for assembling and installing the following accessories:
• Cable Bracket Kit — Quad
• Retractor Bracket Kit — Double
Connectivity brackets allow users to configure the Cable Cubby enclosure with the power
module installed at the center and two cable pass-through modules on the sides (see the image
at the bottom of this page), two retractor assemblies on the sides (see Retractor Bracket Kit -
Double on the next page), or a combination of the two.
NOTE: See the Extron website for a list of compatible brackets to suit the enclosure.
Cable Bracket Kit - Quad
Step 1 — Assemble the cable pass-through brackets
1
Insert cables through the bottom of
the bracket and into holes of the
grommet plate.
3
2
Secure the grommet
plate on the bracket,
using four of the
provided module
screws.
Snap the included hole plugs
into any unused holes
Step 2 — Install cable pass-through brackets in the Cable Cubby
Follow the steps below to install the brackets on the left and right sides of the power
module.
NOTE: For instructions on installing the power module, see the enclosure setup guide.
1
Use the provided mounting screws
and the star washers to secure
the brackets in place.
2
Insert the brackets into
the Cable Cubby.
Connectivity Brackets • Setup Guide (Continued)
68-3159-50
Rev. B
02 18
Retractor Bracket Kit - Double
The retractor bracket lls the empty space between a two-retractor assembly (see image
below) and the center mounted power module. Follow the steps below to install a two-retractor
assembly and the retractor bracket.
Use the provided mounting screws
and the star washers to secure
the brackets in place.
2
2
Use the clip to secure
the mounting pin.
5
Insert the mounting pin
through the retractors.
4
Pin
Clip
Insert the retractor
bracket kit into the
Cable Cubby enclosure
as shown above.
1
Insert the retractors
into the bracket.
3
Retractor Assembly
NOTES:
• For instructions on installing the power module, see the setup guide for the enclosure.
• For instructions on mounting the retractors in the horizontal orientation, see the Cable
Retractor Setup Guide available online at www.extron.com.
© 2017-2018 Extron Electronics — All rights reserved. All trademarks mentioned are the property of their respective owners.
www.extron.com
/
