Anova MPL3245J10A Assembly Instruction

Phone Number: 800.231.1327

TOOLS NEEDED:

• Ratchet with 9/16" socket

• 9/16" open-end or box-end wrench

Assembly Instructions

Connect Modular and Edging Planter Systems

COMPONENT PARTS:

ASSEMBLY HARDWARE: All hardware is stainless steel.

1/4-20 x 7/8"

Hex Head Bolt

1/4"-20

Nylock Nut

Edging

Planter

Section

Modular

Planter

Section

1/4"

Flat Washer

ASSEMBLY:

NOTE: Before assembling the nuts to the bolts, it is recommended that a light oil or petroleum jelly be applied to the bolt

threads.

1. Inspect the shipping container contents for damage and to determine that all components and hardware are present.

NOTE: The amount of hardware will vary depending on the amount of sections that are ordered.

2. Lay out sections in approximate nal locations.

NOTE: Image is example, your product may vary.

Note: Please contact Customer Care at 1-866-797-1761 when ordering replacement parts.

3. Line up the Sections' holes and attach sections with hardware as shown.

NOTE: Tighten hardware to hand tight until all sections are connected

4. Tighten all hardware together.

Drainage Hole Option Dimensions

Edging Planter Connection Points Modular Planter Connection Points

If you are looking to mount your planter products, we recommend using the drainage holes at the

bottom (drainage option must be requested when quoting). Please consult your general contractor

for hardware needs specic to your site.