Fortress Technologies FHT2013 User manual

Fortress Technologies
Brand
Fortress Technologies
Model
FHT2013
Type
User manual
Ceramic Heater
User Manual
MODEL: FHT2013
*Before operating the appliance, please read this manual thoroughly, and retain it for future reference.
CONTENT
PAGE
SAFETY INSTRUCTION
1
PRODUCT FEATURES
3
PARTS DESCRIPTION
4
OPERATION INSTRUCTION
5
MAINTENANCE INSTRUCTION
8
SPECIFICATION
8
WARRANTY
9
1
SAFETY INSTRUCTION
1. To avoid electric shock, fire or injury, please read the user manual carefully before using the
appliance and keep it for future reference.
2. This appliance is for household use only. Please use suitable power source (220-240V~/50Hz).
3. Never immerse the appliance in water or other liquids.
4. Do not use the appliance under direct sunshine.
5. Please turn off the appliance when not in use otherwise it may result in danger.
6. Please turn off the appliance and unplug the socket when unattended otherwise it may result in
danger.
7. Keep the appliance away from children.
8. This appliance can be used by children aged from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance in a safe way and understand the
hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall
not be made by children without supervision.
9. Children of less than 3 years should be kept away unless continuously supervised.
10. Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided
that it has been placed or installed in its intended normal operating position and they have been
given supervision or instruction concerning use of the appliance in a safe way and understand the
hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and
clean the appliance or perform user maintenance.
11. With any indication of malfunction (including power cord), please stop using the appliance
immediately to avoid hazard. Take it to the authorized service center for repair. Do not attempt to
repair or change any parts by yourself.
12. Please turn off and unplug the appliance before cleaning or maintenance.
13. Clean the surface of the appliance with dry cloth. Do not use corrosive detergent or solvent to clean.
Do not swash the appliance with water.
14. Please turn off and unplug the appliance when not in use. Make sure the power is off before pulling
out the plug and do not pull the cord.
2
15. When the appliance is not in use for a prolonged period, please turn it off, unplug it, pack it well
and store it in dry cool place.
16. Forbid to put flammable and explosive objects around the appliance, and do not use the appliance
in an environment full of flammable gas and powder. Keep away from any fire and heat sources.
17. Please put the power cord in the right place in order to avoid tripping the appliance over.
18. Do not put any objects on the appliance and put the appliance immediately below a socket-outlet.
19. Do not touch the air outlet when operating.
20. Please keep the air inlet and the air outlet unblocked to minimize the risk of fire or malfunction.
21. Do not let the power cord touch or near the air outlet. It will damage the insulation layer of wires.
22. Please operate the appliance on a firm and level desk or floor. Do not use the appliance in the
immediate surroundings of a bath, a shower or a swimming pool.
23. Ensure no water or raindrop leak into the appliance in order to avoid electric shock. Do not put
flammable objects or wet clothes on the air outlet in order to avoid short circuit or fire.
24. Please do not place the air inlet or the air outlet near to curtains or walls when operation because it
will block the air current and cause fire. The appliance should be installed at minimum distant of 10
cm from the wall or other obstacles.
25. Please do not insert any objects into the air inlet or the air outlet in order to avoid electric shock.
26. After a period of operation, abnormal noise and uneven air volume may appeared because of dust
blocking the airflow. It will disappear after cleaning the back net.
WARNING: In order to avoid overheating, do not cover the appliance with anything,
especially flammable materials, such as clothes or paper.
CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cutout,
this appliance must not be supplied through an external switching device, such as a timer, a
programmer, separate remote-control system or connected to a circuit that is regularly
switched on and off by the utility.
CAUTION: Some parts of this product can become very hot and cause burns. Particular
attention has to be given where children and vulnerable people are present.
3
PRODUCT FEATURES
2 heating power options
Temperature setting 15
o
C – 35
o
C
ECO function
LED display
Oscillation function
Timer: 1-24 hours
Double overheat protection
Tip-over protection
Remote Control
4
PARTS DESCRIPTION
① Control panel
② ECO button
③ LED display
④ Front case
⑤ Metal fence
⑥ Swing bracket
⑦ Base
⑧ Back case
⑨ Back net
⑩ Power switch
5
OPERATION INSTRUCTION
Connect the power cord to the correct power supply (220-240V~/50Hz).
Power switch
The power switch is at the bottom of the back case.
Press the power switch to “I” position, you will hear a “beep-beep” sound and the power indicator will
be on. The heater will be in standby mode. Press the power switch to “O” position, the power and the
power indicator will be off.
LED Display
ECO button
High/low power
heating button
Temperature/timer
setting button
+ button
ON/OFF
button
Control Panel
Power indicator
Temperature/ timer
display
High/low heating
power indicator
ECO indicator
Oscillation indicator
- button
(For temperature/timer setting)
6
ON/OFF button ( )
Press the ON/OFF button to turn on the appliance and it will start running in low heating power. The
default temperature setting is 25℃. The temperature/timer display shows the room temperature and
the high/low heating power indicator shows “ ”. Press the ON/OFF button again, the heater will be
stopped in 10 seconds and go into standby mode, and the power indicator will be still on.
Temperature/timer display: When the room temperature is ≤-10℃, it will show as “LO”, when the
room temperature is >40℃, it will show as “HI”. When the room temperature is between -9℃ to 40℃, it
will show the room temperature.
High/Low heating power button ( )
Press the high/low heating power button to change high or low heating power during operation.
Low heating power: The high/low heating power indicator shows “ ”
High heating power: The high/low heating power indicator shows “ ”
Oscillation button ( )
Press the oscillation button to activate the oscillation function during operation. The oscillation indicator
will be on. Press the oscillation button again, the oscillation function will be stopped and the oscillation
indicator will be off.
Temperature/timer setting button ( )
Press the temperature/timer setting button to set the temperature or timer during operation.
A: Set the Timer
After pressing the temperature/timer setting button, the temperature/timer display will show “0H”.
Press the “+” or the “-” button to set the auto off time with a range of 1-24 hours. The timer will be
added or reduced by 1 hour for each press of the “+” or the “-” button. The temperature/timer display
will flash for 5 seconds, and the setting will be completed.
Note: After pressing the temperature/timer setting button, the temperature/timer display will flash for 5
seconds. You can press the “+” or the “-” button to set the auto off time within 5 seconds. If the heater
do not receive any instruction, or buttons other than the temperature/timer setting button, the “+” button
or the “-” button are being pressed within 5 seconds, the temperature/timer display will then resume to
display the room temperature.
7
B: Set the Temperature
After setting the timer, press the temperature/timer setting button again, the temperature/timer display
will show 25℃, now you can set the temperature. Press the “+” or the “-” button to set the temperature
with a range of 15-35℃. The temperature will be added or reduced by 1℃ for each press of the “+” or
the “-” button. The temperature/timer display will flash for 5 seconds, and the setting will be completed.
Note: In temperature setting mode, the temperature/timer display will flash for 5 seconds. You can press
the “+” or the “-” button to set the temperature within 5 seconds. If the heater do not receive any
instruction, or buttons other than the temperature/timer setting button, the “+” or the “-” button are being
pressed within 5 seconds, the temperature/timer display will then resume to display the room
temperature.
ECO button ( )
Press the ECO button to activate the ECO mode during operation. The ECO indicator will be on Press
the ECO button again, the ECO mode will be stopped and the ECO indicator will be off.
ECO mode: The default temperature setting is 22
o
C. When the room temperature is equal or lower than
18
o
C, high power heating will turn on; when the room temperature is higher than 18
o
C, low power
heating will turn on. When the room temperature reaches 22
o
C, the heating element will turn off.
REMOTE CONTROL OPERATION
PICTURE 1
PICTURE 2
Operation instruction of remote control
1. Pull out the battery door at the back side of remote control (Picture 1)
2. Insert a battery into the tray of the door. (Picture 2)
3. Insert the battery door back into the remote control.
8
Remote control panel
There are seven function keys on the remote control and their functions are same as those keys on the
control panel of the heater. While operating the remote control, point the remote control to the heater.
The signal distance is about 6M.
MAINTENANCE INSTRUCTION
1. Please turn off and unplug the appliance before cleaning or maintenance.
2. Clean the surface of the appliance with dry cloth. Do not use corrosive detergent or solvent to
clean. Do not swash the appliance with water.
SPECIFICATION
Model No.
FHT2013
Product name
Ceramic Heater
Rated Voltage / Frequency
220-240V~ / 50Hz
Rated Power
Low:1300W / High:2000W
Temperature / Timer Setting
15
o
C – 35
o
C /1-24h
Dimensions (WxHxD)
233x584x179 mm
Net Weight
2.2kg
Oscillation
button
ON/OFF
button
+ button
- button
High/low heating
power button
Temperature/timer
setting button
ECO button
9
WARRANTY
1. The product has 2 years warranty from the date of purchase.
2. The warranty shall not apply:
A. to any product subjected to misuse, alteration, act of God, improper handling, improper transport, improper testing or unauthorized
repair;
B. to cosmetic problems or defects which result from normal wear and tear under ordinary use yet not affecting the performance or
use of the product;
C. if the product is disassembled or altered;
D. to any packing, transportation, export / import tax or any related expenses.
3. CUSTOMER MUST PRESENT THE SALES INVOICE OR RECEIPT FOR 2 YEARS WARRANTY SERVICES.
4. Please bring along the product and sales invoice or receipt to our services center for warranty services during office hour:
Address : Unit A, 20/F, Yip Shing Industrial Centre, No.19, Yip Shing Street, Kwai Chung.
Service Hotline : (852) 2428 1500
Service Hours
Monday-Friday : 9:00am - 6:00pm
Saturday : 9:00am - 4:00pm
Sunday & Public Holiday : Closed
5. To prevent circuit overload and fire, no more than one adaptor or one extension unit should be inserted into a socket outlet. (Do not
connect other appliances to the socket outlet supplying an electric heater.) No adaptor should be inserted into any extension unit or vice
versa.
6. Stop using an adaptor or an extension unit or a socket if its socket holes cannot firmly hold a plug or it is too hard to insert a plug into it.
7. This appliance must be plugged into a specific socket for 220V with no less than 10A provided. Please make sure the plug is fully
plugged-in before use. Do not use any adapter or extension cord; Never use the same supply socket for this appliance and other
appliances at the same time, in order to avoid damage to this appliance.
8. THE APPLIANCE IS FOR HOUSEHOLD USE ONLY.
ENVIRONMENT
Do not throw away the appliance with the normal household waste at the end of its life, but hand it in at an official
collection point for recycling. By doing this, you help preserving the environment.
IMPORTANT NOTICES
THE UNIT IS FOR DOMESTIC USE ONLY
IN NO EVENT SHALL OUR COMPANY OR THE SUPPLIER BE LIABLE TO YOU OR ANY OTHER PARTY FOR ANY DIRECT,
INDIRECT, GENERAL, SPECIAL, INCIDENTAL, CONSEQUENTIAL, EXEMPLARY OR OTHER DAMAGES ARISING OUT OF
THE USE OR INABILITY TO USE THE PRODUCT (INCLUDING, WITHOUT LIMITATION, DAMAGES FOR INJURY, LOSS OF
PROPERTY, BUSINESS PROFITS, BUSINESS INTERRUPTION) OR FROM ANY BREACH OF WARRANTY, EVEN IF OUR
COMPANY OR SUPPLIER HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. IN NO CASE SHALL OUR
COMPANY OR SUPPLIER’S LIABILITY EXCEED THE AMOUNT YOU PAID FOR THE PRODUCT.
Specifications, designs and dimensions are subject to change without prior notice.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11

Fortress Technologies FHT2013 User manual

Fortress Technologies
Brand
Fortress Technologies
Model
FHT2013
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents