2. Toro
  3. KIT-BOX ENCLOSURE, PR [HDX]
KIT-BOX ENCLOSURE, PR [HDX]

Toro KIT-BOX ENCLOSURE, PR [HDX] User manual

  • Hello! I am an AI chatbot trained to assist you with the Toro KIT-BOX ENCLOSURE, PR [HDX] User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
NOTE: Read these Installation Instructions thoroughly before beginning the installation process. Retain
these Installation Instructions for future reference.
Arctic Cat
®
Prowler
Installation Instructions - Accessory Kit
Form No. 0453-919
HDX Box Enclosure Kit
(p/n 1436-930)
Kit includes:
p/n QTY DESCRIPTION
N/A 1 Box Enclosure
1541-002 1 Front Aluminum Support Tube
1541-003 1 Rear Aluminum Support Tube
1541-004 2 Webbing Straps w/ Plastic Retainers
1514-005 2 Webbing Straps w/Release Buckles
1541-006 2 Hinge
1423-011 4 Machine Screw
2441-299 2 Jaw Slide
0453-919 1 Instructions
1. Fasten the cargo box mount to the top edge of the
cargo box using the supplied screws. The inside of
the mount should be even with the inside edge of
the cargo box. Secure the mount centered at 21.5
inches. from the rear of the front handle on top of
the cargo box edge. See Fig. 1.
Fig. 1
ROV-346A
2. Remove the machine screws from the underside of
the tailgate. Thread strap between bed and tailgate.
Install strap using the same screw going through
the hole in the strap. Be sure to install the corre-
sponding buckle strap as it mates to the buckle on
the enclosure. See Fig. 2.
Fig. 2
ROV-335A
3. Wrap the front webbings around the front bed sup-
port bar. Fully connect overlap Velcro. Velcro
around the front bar should be adjusted to the top
when spacers for the cab are in the front of the
bed. Lower when not. See Fig. 3.
Fig. 3
ROV-349A
4. Feed the front/side webbing around the cargo box
and thread the end of the strap through the buckle.
See Fig. 4.
Fig. 4
ROV-348A
5. Raise the enclosure and connect side webbing/Vel-
cro wraps through the tie-down access holes on the
bed. To raise the front bow, pull up evenly to allow
the poles to telescope. See Fig. 5.
Fig. 5
ROV-347A
6. Remove the tailgate latch bolt on the rear edge of
the cargo box and replace going through the hole in
the webbing with the plastic retainer. See Fig. 6.
Fig. 6
ROV-351
7. Thread the webbing/Velcro strap through the plas-
tic retainer. See Fig. 7.
Fig. 7
ROV-350
Printed in the U.S.A. ®™Trademarks of Arctic Cat Inc., Thief River Falls, MN 56701 0913
8. Connect the buckles on the bed enclosure to the
webbing/buckle straps attached to the tailgate. To
stow the enclosure; push the buttons to collapse the
side down and use the Velcro wraps to secure.
/