Page is loading ...
How to replace the rear burner ignition wire
Step 1: Take out the bolts as the picture shows.
Step 2: Take out the bolts to get the rear burner cover out.
Step 3: Take out the bolts as the picture shows.
Step 4: Take out the bolts as the picture shows.
Step 5: Gently draw the rear burner ignition wire out.
Step 6: Take out the rear burner ignition pin holder.
Step 7: Take out the bolts as the picture shows.
Step 8: Take out the side shelf as the picture shows.
Step 9: Take out the bolts to get the fat tray support bracket out.
Step 10: Pull out the side burner ignition wire.
Step 11: Take out the bolt from the side burner injector bracket.
Step 12: Take out the bolts as the picture shows.
Step 13: Take out the side burner shelf as the picture shows.
Step 14: Take out the bolts as the picture shows (both sides).
Step 15: Take out all the knobs.
Step 16: Remove all screws from the knob bezel.
Step 17: Loosen the ignition box.
Step 18: Gently draw the Fascia out.
Step 19: Separate the rear burner ignition wire as the picture shows.
Step 20: Replace with a new rear burner ignition wire.。
Step 21: Reverse steps above to install the parts back. Please pay attention when
installing the fascia, since each injector on the manifold must aim at the burner
inlets.
/
