2. Garth
  3. Manifold
Manifold

Garth Manifold Operating instructions

  • Hello! I've reviewed the user manual for replacing the manifold set. This document provides step-by-step instructions for removing the old manifold and installing a new one, including removing various parts like bolts, the side shelf, the ignition wire, and flexible pipes. I'm ready to assist with any questions you might have about the process.
  • What is the first step in replacing the manifold set?
    What should be done after removing the bolts in step 1?
    What are the last steps in the manifold replacement?
How to replace the manifold set
Step 1: Take out the bolts as the picture shows.
Step 2: Take out the side shelf as the picture shows.
Step 3: Pull out the side burner ignition wire.
Step 4: Take out the bolt from the side burner injector bracket.
Step 5: Take out the bolts as the picture shows
Step 6: Take out the side burner shelf as the picture shows.
Step 7: Take out the bolts as the picture shows (both sides).
Step 8: Take out all the knobs.
Step 9: Remove all screws from the knob bezel.
Step 10: Loosen the ignition box.
Step 11: Gently draw the fascia out.
Step 12: Remove the side burner flexible pipe, rear burner flexible pipe and the
regulator as shown below.
Step 13:
A. Replace with a new manifold and conduct a leak test.
B. Reverse steps above to install the parts back. Please pay attention when
installing the fascia, since each injector on the manifold must aim at the
burner inlets.
/