2. Garth
  3. Rear Burner Ignition Wire Replacement

Garth Rear Burner Ignition Wire Replacement Operating instructions

  • Hello! I've reviewed the provided user manual on replacing the rear burner ignition wire. This document gives a concise, step-by-step guide with visual aids on how to safely remove and replace the component. I'm ready to assist you with any questions about the process or the device mentioned in the manual.
  • What is the first step in replacing the rear burner ignition wire?
    What should you do after taking out the bolts?
How to replace the rear burner ignition wire
Step 1: Take out the bolts to get the rear burner cover out as the picture shows.
Step 2: Take out the bolts, then gently draw the rear burner ignition wire out.
Step 3: Separate the rear burner ignition pin holder as shown in the following image.
Step 4: Take out the bolts as the picture shows.
Step 5: Get the fat tray support bracket out as the picture shows.
Step 6: Take out the bolts as the picture shows.
Step 7: Take out the bolts as the picture shows.
Step 8: Gently draw the fascia out as following image shows.
Step 9: Separate the rear burner ignition wire as the picture shows.
Step 10:
A. Replace with a new rear burner ignition wire.
B. Reverse steps above to install the parts back. Please pay attention when
installing the fascia, since each injector on the manifold must aim at the burner
inlets.
/