2. Garth
  3. Manifold
Manifold

Garth Manifold Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Garth Manifold Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
How to replace the manifold set
Step 1: Take out the bolts as the picture shows.
Step 2: Loosen the fixing screws 3mm as the picture shows.
Step 3: Loosen the fixing screw 3mm as the picture shows.
Step 4: Take out the bolts of the side burner injector holder.
Step 5: Take out the bolts as the picture shows.
Step 6: Loosen the fixing screws 3mm as the picture shows.
Step 7: Loosen the fixing screw 3mm as the picture shows.
Step 8: Take out the bolt of the fascia as the picture shows.
Step 9: Gently draw the fascia out as following image.
Step 10: Take out all the knobs.
Step 11: Remove all screws from the knob bezel.
Step 12: Take out all the knob light connection end.
Step 13: Gently draw the fascia out as the following image shows.
Step 14: Separate the ignition wire as following image shows.
Step 15: Remove the side burner flexible pipe, rear burner flexible pipe and the
regulator as shown on image.
Step 16:
A. Replace with a new manifold and conduct a leak test.
B. Reverse steps above to install the parts back. Pay attention when installing
the fascia, since each injector on the manifold must aim at the burner inlets.
/