Garth Side Operating instructions

Type
Operating instructions
How to replace the fascia
Step 1: Take out the bolts as the picture shows on.
Step 2: Take out the bolts as the picture shows on.
Step 3: Gently draw the fascia out as the following image shows.
Step 4: Take out all the knobs.
Step 5: Remove all screws from the knob bezel.
Step 6: Take out all the knob light connection end.
Step 7: Separate the rear burner ignition wire as the picture shows.
Step 8: Loosen the ignition box as the picture shows.
Step 9: Separate the knob light line as the picture shows.
Step 10: Loosen the knob light switch as the picture shows.
Step 11: Replace with a new fascia.
Step 12: Reverse steps above to install the parts back. Please pay attention when
installing the fascia, since each injector on the manifold must aim at the burner
inlets.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

Garth Side Operating instructions

Type
Operating instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI