2. Road Armor
  3. Stealth Front Skid Plate

Road Armor Stealth Front Skid Plate, 5182SPB, 5183SPB Installation guide

  • Hello! I've reviewed the installation instructions for the ROAD ARMOR Front Skid Plates, models 5182SPB and 5183SPB. This document covers the installation process for both the mid-width and full-width options, and is intended for 2018+ Jeep Wrangler JL and 2020+ Jeep Gladiator JT vehicles. I'm ready to answer any questions you might have about the installation, compatible vehicles, or the hardware provided.
  • What vehicles are compatible with the skid plates?
    What are the two different options for the skid plates?
    What is included in the hardware kit?
Page ( 1 of 3 )
INSTALL INSTRUCTIONS
Jeep JL Front Skid Plate
Products: 5182SPB(Mid-Width), 5183SPB(Full-Width),
Applicaon : 2018+ Jeep Wrangler JL
2020+ Jeep Gladiator JT
2018+ Jeep Wrangler JL Front Skid Plate Page ( 2 of 3)
www.ROADARMOR.com
INSTALL INSTRUCTIONS
SAFETY FIRST!
• FOLLOW ALL INSTRUCTIONS, YOUR SAFETY AND THE SAFETY OF OTHERS IS MOST IMPORTANT.
• WEAR APPROPRIATE EYE PROTECTION AND EXERCISE CAUTION
REQUIRED TOOLS
INCLUDED HARDWARE
I WARNING
Read the instrucons completely before beginning installaon. Before ghtening bolts,
drilling or cung where required, check to make sure there are no obstrucons such as
brake, fuel or electrical lines which may be damaged. Also keep in mind this is an aer-
market product and MAY require minor shimming and/or trimming, reaming, etc. for
proper t. Road Armor is not responsible for any damages to vehicle.
IMPORTANT NOTICE
• Be sure to inspect and test t your product to ensure proper tment before having it coated, painted, bed
lined, etc.
• Road Armor will not be responsible for the cost of coang your unit if any problems with t or nish are not
noted and addressed beforehand.
Metric and SAE Socket Sets and Wrenches
(9) 3/8-in x 1-in Hex Head Bolt Tabs
(9) 3/8-in Lock Nuts
(18) 3/8-in Small Washers
2018+ Jeep Wrangler JL Front Skid Plate Page ( 3 of 3)
www.ROADARMOR.com
INSTALL INSTRUCTIONS
1 Install Road Armor Accessory Mid-Width (PN#5182SPB)
2 Install kit skid plate to lower secon of bumper with kit 3/8” bolts (9), washers (18) and lock nuts
(9) loosely; once aligned ghten all hardware. FINISHED!
13
1 Install Road Armor Accessory Full-Width (PN#5183SPB)
2 Install kit skid plate to lower secon of bumper with kit 3/8” bolts (5), washers (10) and lock nuts
(5) loosely; once aligned ghten all hardware. FINISHED!
2
/