Road Armor 518AFFWB Installation guide

Brand
Road Armor
Model
518AFFWB
Category
Car kits
Type
Installation guide

This manual is also suitable for

INSTALL INSTRUCTIONS
Applicaon : 2018+ Jeep Wrangler JL
JL REAR FENDER FLARE: 518AFR0B
*NOTE WILL NOT ACCOMIDATE FULL WIDTH BUMPER*
(5183R0B & 5183R1B-TC)
2018+ JEEP JL REAR FENDER FLARES Page ( 2 of 9 )
www.ROADARMOR.com
INSTALL INSTRUCTIONS
SAFETY FIRST!
• FOLLOW ALL INSTRUCTIONS, YOUR SAFETY AND THE SAFETY OF OTHERS IS MOST IMPORTANT.
• WEAR APPROPRIATE EYE PROTECTION AND EXERCISE CAUTION WHEN DRILLING / CUTTING
REQUIRED TOOLS
INCLUDED HARDWARE
I WARNING
Read the instrucons completely before beginning installaon. Before ghtening bolts,
drilling or cung where required, check to make sure there are no obstrucons such as
brake, fuel or electrical lines which may be damaged. Also keep in mind this is an aer-
market product and MAY require minor shimming and/or trimming, reaming, etc. for
proper t. Road Armor is not responsible for any damages to vehicle.
IMPORTANT NOTICE
• Be sure to inspect and test t your product to ensure proper tment before having it coated, painted, bed
lined, etc.
• Road Armor will not be responsible for the cost of coang your unit if any problems with t or nish are not
noted and addressed beforehand.
Metric and SAE Socket Sets and Wrenches
Drill & Unibit & 17/32” Drill Bit
Rivet Nut Tool
(4) 5/16”x1” Carriage Bolts
(16) 5/16”x1” Bolts
(18) 5/16” Flange Nuts
(2) 5/16” Rivet Nut
(4) 5/16” Push Retainer Washers
(16) 5/16” Washers
140” Rubber Edge Trim
(1) PSG FENDER FLARE
(1) DVR FENDER FLARE
2018+ JEEP JL REAR FENDER FLARES Page ( 3 of 9 )
www.ROADARMOR.com
INSTALL INSTRUCTIONS
1 Remove 8 plasc clips from each inner wheel well.
NOTE **If you are installing Road Armor INNER FENDER LINERS skip STEP 2**
2 MARK, CUT and REMOVE plasc OEM LINER as shown below. (KEEPING STOCK FENDER LINERS)
3 Remove rear fender assembly by rmly pulling on one end of fender unl all 12 clips “pop o”.
2
1
2018+ JEEP JL REAR FENDER FLARES Page ( 4 of 9 )
www.ROADARMOR.com
INSTALL INSTRUCTIONS
1 Cut out each kit DRIVER AND PSG SIDE TEMPLATES (4 pcs) found at the end of instrucons. Cut out
hole without “crosshairs”. Align TEMPLATES with exisng fender holes and fender well edge.
2 Aer TEMPLATES are secured with tape, center punch and drill 3 holes to 3/8” (RED ARROWS)
3 Drill 5 exisng holes to 3/8” as shown with BLUE ARROWS.
FRONT DVR SIDE REAR DVR SIDE
TOP
TOP
2
3
2018+ JEEP JL REAR FENDER FLARES Page ( 5 of 9 )
www.ROADARMOR.com
INSTALL INSTRUCTIONS
1 Drill front lower hole to 17/32” as shown below.
2 Insert 1 - 5/16” RIVET NUT using rivet tool.
3 Assembly REAR FENDER using 2 - 5/16”
CARRIAGE BOLTS and PUSH RETAINER WASHERS.
17/32”
.0531”
4 Install EDGE TRIM along main fender edge to protect body. (Insert at side of trim on boom.)
3
1
3
4
2018+ JEEP JL REAR FENDER FLARES Page ( 6 of 9 )
www.ROADARMOR.com
INSTALL INSTRUCTIONS
1 Install REAR FENDER FLARE by inserng both REAR CARRIAGE BOLTS into lower rear holes rst.
2 Connue installing FENDER FLARES using 5/16” HARDWARE as shown below.
**INSTALL ROAD ARMOR INNER FENDER LINERS or OEM LINERS AT THIS TIME** STOP
STOP
2
2018+ JEEP JL REAR FENDER FLARES Page ( 7 of 9 )
www.ROADARMOR.com
INSTALL INSTRUCTIONS
1 Push EDGE TRIM against body for nished look without “gapping”.
FINISHED!
3
2
2 **ONLY WHEN INSTALLING RA-LINERS**
Install/wedge 2 - FLANG NUT COVERS onto
back side of seam and 5/16” BOLT & NUTS.
3 Tighten all 5/16” HARDWARE at this me.
2018+ JEEP JL REAR FENDER FLARES Page ( 8 of 9 )
www.ROADARMOR.com
INSTALL INSTRUCTIONS
TOP
TOP
2018+ JEEP JL REAR FENDER FLARES Page ( 9 of 9 )
www.ROADARMOR.com
INSTALL INSTRUCTIONS
TOP
TOP
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9

Road Armor 518AFFWB Installation guide

Brand
Road Armor
Model
518AFFWB
Category
Car kits
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents