Danfoss BasicGrip - Liquid screed User guide

Application sheet

BasicGrip

Carpet / tiles / parquet / laminate / synthetics

Liquid screed

1 Carpet / tiles / parquet

2 Liquid screed (≥ CAF F5) 50 mm

3 FH composite pipe (16 mm)

4 BasicGrip panel 11 mm insulation 11 mm

5 Insulation WLG 040 70 mm

6 Basic perimeter insulation

7 BasicGrip PE-string (18 mm)

Floor nish NA mm Carpet / tiles / parquet / laminate / synthetics

Construction height 131 mm Height excluding oor nish

Weight ~ 112 kg / m² Weight excluding oor nish

Thermal resistance R 2,06 m²K / W The minimum thermal resistance requirement of DIN EN 1264 is

fullled.

Thermal transmission coecient U 0,45 W / m²K If the architectural design species better thermal insulation, this

must be taken into account.

Design load ≤ 2,0 kN / m²

Point load (≥ 20 cm²) ≤ 1,0 kN

Application area

Residential spaces, hallways and attic spaces in residential buildings and hotel rooms.

Corresponds to categories A1, A2 and A3 of DIN 1055-3.

Requirements & special features

A screed thickness of 60 mm must be maintained with CAF-F4 tile screeds.

The screed thicknesses must be adjusted in case of higher design load or point load

values.

Observe all installation instructions and manufacturer’s instructions.

Additional insulation

Insulation: 70 mm EPS 040 DEO

Construction

According to EnEV, EN 1264, DIN 4109, 1055 and 18560

Construction number 174

Technical Data Floors/ceilings exposed to outside air

VA.CT.W1.02

Danfoss HES