Danfoss BasicGrip - Liquid screed User guide

Application sheet

BasicGrip

Carpet / tiles / parquet / laminate / synthetics

Liquid screed

1 Carpet / tiles / parquet

2 Liquid screed (≥ CAF F5) 50 mm

3 FH composite pipe (16 mm)

4 BasicGrip panel 35mm insulation 35 mm

5 Insulation WLG 040 50 mm

6 Basic perimeter insulation

Floor nish NA mm Carpet / tiles / parquet / laminate / synthetics

Construction height 135 mm Height excluding oor nish

Weight ~ 112 kg / m² Weight excluding oor nish

Thermal resistance R 2,1 m²K / W The minimum thermal resistance requirement of DIN EN 1264 is

fullled.

Thermal transmission coecient U 0,44 W / m²K If the architectural design species better thermal insulation, this

must be taken into account.

Design load ≤ 2,0 kN / m²

Point load (≥ 20 cm²) ≤ 1,0 kN

Impact subsonic noise reduction 28 dB Calculated value according to DIN 4109; applies to concrete slabs

thicker than 12 cm (DIN 4109: m² > 276 kg/m²).

Application area

Residential spaces, hallways and attic spaces in residential buildings and hotel rooms.

Corresponds to categories A1, A2 and A3 of DIN 1055-3.

Requirements & special features

A screed thickness of 60 mm must be maintained with CAF-F4 tile screeds.

The screed thicknesses must be adjusted in case of higher design load or point load

values.

Observe all installation instructions and manufacturer’s instructions.

Additional insulation

Insulation: 50 mm EPS 040 DEO

Construction

According to EnEV, EN 1264, DIN 4109, 1055 and 18560

Construction number 180

Technical Data Floors/ceilings exposed to outside air

VA.DY.C1.02

Danfoss HES